Related Experiment Video
Updated: Jun 28, 2025

A Protocol for Conducting Rainfall Simulation to Study Soil Runoff
Published on: April 3, 2014
Stability analysis of rainfall-induced landslide considering air resistance delay effect and lateral seepage
Li Li1, Hanjie Lin2, Yue Qiang2
1Department of Civil Engineering, Chongqing Three Gorges University, Wanzhou, Chongqing, 404100, China. lily6636694@163.com.
Abstract:
Accumulation landslides are prone to occur during the continuous infiltration of heavy rainfall, which seriously threatens the lives and property safety of local residents. In this paper, based on the Green-Ampt (GA) infiltration model, a new slope rainfall infiltration function is derived by combining the effect of air resistance and lateral seepage of saturated zone. Considering that when the soil layer continues to infiltrate after the saturation zone is formed, the air involvement cannot be discharged in time, which delays the infiltration process. Therefore, the influence of air resistance factor in soil pores is added. According to the infiltration characteristics of finite long slope, the lateral seepage of saturated zone is introduced, which makes up for the deficiency that GA model is only applicable to infinite long slope. Finally, based on the seepage characteristics of the previous analysis, the overall shear strength criterion is used to evaluate the stability of the slope. The results show that the safety factor decreases slowly with the increase of size and is inversely correlated with the slope angle and initial moisture content. The time of infiltration at the same depth increases with the increase of size and slope angle, and is inversely correlated with the initial moisture content, but is less affected by rainfall intensity. By comparing with the results of experimental data and other methods, the results of the proposed method are more consistent with the experimental results than other methods.
Related Concept Videos
Design Example: Analyzing Capacity Contours for Flood Risk Assessment
Design Example: Forces in Sluice Gate
Key variables in...
Design Example: Maintaining Level of an Embankment
Design Example: Creating a Hydraulic Model of a Dam Spillway
Relation Between the Distributed Load and Shear
Conservation of Mass in Moving, Nondeforming Control Volume
In the context of a detention basin, the conservation of mass states that the total mass of water entering the basin must equal the mass leaving the basin plus any accumulation of...

