Hot Cordilleran hinterland promoted lower crust mobility and decoupling of Laramide deformation

Dominik R Vlaha1,2,3, Andrew V Zuza4,5, Lin Chen6

  • 1Nevada Bureau of Mines and Geology, University of Nevada, Reno, NV, USA. dvlaha@unr.edu.

PubMed

Related Concept Videos

Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
147
Magnetostatic Boundary Conditions01:28

Magnetostatic Boundary Conditions

An electric field suffers a discontinuity at a surface charge. Similarly, a magnetic field is discontinuous at a surface current. The perpendicular component of a magnetic field is continuous across the interface of two magnetic mediums. In contrast, its parallel component, perpendicular to the current, is discontinuous by the amount equal to the product of the vacuum permeability and the surface current. Like the scalar potential in electrostatics, the vector potential is also continuous...
909
Influence of Earth's Curvature and Atmospheric Refraction on Leveling01:26

Influence of Earth's Curvature and Atmospheric Refraction on Leveling

During leveling, the Earth's curvature and atmospheric refraction introduce deviations in the line of sight from a true horizontal reference. When the line of sight is leveled, it remains perpendicular to the plumb line only at a single point. Beyond this, it deviates due to the Earth’s curvature, represented by the correction C. For a sight distance D, the deviation can be derived using the relationship:This relationship shows that the deviation increases quadratically with distance.
92
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
164
Significance of Displacement Current01:27

Significance of Displacement Current

A displacement current is analogous to a real current in Ampère's law, participating in Ampère's law the same way as the usual conduction current. However, it is produced by a changing electric field. Displacement current is defined in terms of a time-varying electric field, and also has an associated displacement current density. By adding a term accounting for displacement current, Maxwell modified the existing Ampère's law, which is now called generalized Ampère's law.
4.5K
Coriolis Force01:23

Coriolis Force

An accelerating particle experiences a force equal to the mass multiplied by the acceleration in an inertial frame of reference. Consider a particle in a non-inertial frame of reference, such as a sliding ball on a rotating table. The acceleration of the ball in this rotating reference frame is different than in the intertial frame, which modifies its equation of motion. The fictitious forces acting additionally on a rotating frame of reference alter Newton's Second Law expression.
3.4K