Resilient event-triggered observer-based control of non-linear systems under denial-of-service attacks with actuator
Muhammad Ahsen Ali1, Naeem Iqbal1, Muhammad Rehan1
1Department of Electrical Engineering, Pakistan Institute of Engineering and Applied Sciences (PIEAS), Islamabad, Pakistan.
Abstract:
This paper studies the control problem for a continuous-time networked system with non-linearity in the state equation as well as in the input, as saturation. The system is considered under denial-of-service (DoS), attacks which cause the blockage of input and/or output components in the overall closed-loop model. An event-triggering scheme that is resilient in nature, along with an observer-based control, has been considered under DoS attacks. The resultant scheme ensures efficient network resources and excludes Zeno behavior naturally due to the presence of a minimum positive interevent delay. Then, an event-based switched non-linear model is presented to address both the event-triggering scheme and the presence of DoS blocking attacks. A piece-wise Lyapunov-Krasovskii functional method on the described non-linear model, resulting in the switched system, is considered for achieving an exponentially stable response by driving the required feasibility conditions. In the presence of a non-linear system with saturation in the actuator, the presented design establishes quantitative relationships among the exponential decay rate, active/sleeping intervals of attacks, parameters of the event-triggering condition, and sampling period of the system. After that, linear matrix inequalities are presented for designing an event-triggered controller with an observer, while the design also includes the region of convergence for dealing with the input non-linearity. Finally, comparative results for an offshore structure model with non-linearity in states as well as in actuator, are demonstrated to verify the results of the control scheme that is developed. It has been verified that our design is less conservative than the previous designs, and can handle the non-linearities in the dynamics of plant and actuator saturation more efficiently, while DoS attacks are also present. By applying our proposed method, the overshoot and undershoot are less than ±2.5 percent, while system states converge to the origin within 55 s.
Related Concept Videos
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Control Systems
At the heart...
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal...
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Radial System Protection
In a radial system with a fault downstream of the third breaker, ideally, only the third breaker will open, isolating the fault and interrupting the load connected beyond it. The second breaker has a longer delay setting,...


