Physical Model of Inclusions Removal at Static Steel-Slag Interface

Inclusions are one of the important factors affecting the cleanliness of molten steel. The current optimization of inclusion removal methods mainly focuses on promoting inclusions to float to the slag-steel interface so that the inclusions can be absorbed and removed by the refining slag. However, the research on the floating removal of inclusions cannot be carried out directly in the ladle, so methods such as mathematical models and physical models were developed. This article uses silicone oil to simulate the slag layer; polypropylene particles; and aluminum oxide particles to simulate inclusions to establish a water model experiment. By changing the viscosity of silicone oil and the diameter of particles, the factors affecting the movement of inclusions at the slag-steel interface were explored. Based on the water model, a mathematical model of the floating behavior of inclusions at the slag-steel interface was constructed, and parameters such as particle diameter and interfacial tension in the water model experiment were studied by the mathematical model for calculation. Both the mathematical model and the water model experimental results show that after the viscosity of silicone oil increases from 0.048 Pa·s to 0.096 Pa·s, the dimensionless displacement and terminal velocity of the particles decreases. When the diameter of the same particle increases, the dimensionless displacement and terminal velocity increases. The dimensionless displacement of polypropylene particles of the same diameter is larger than that of aluminum oxide particles, and the terminal velocity is smaller than that of aluminum oxide particles. This is attributed to the better overall three-phase wettability of polypropylene particle. When the liquid level increases, the dimensionless displacement and terminal velocity of particles under the same conditions show only slight differences (less than 10%).