Jaw Thrust: A Simple Predictor of Success in Mandibular Distraction Osteogenesis

Okensama M La-Anyane1, Kelly A Harmon1, Nikki Rezania1

  • 1Division of Plastic and Reconstructive Surgery.

Abstract

Related Concept Videos

Determination01:51

Determination

During embryogenesis, cells become progressively committed to different fates through a two-step process: specification followed by determination. Specification is demonstrated by removing a segment of an early embryo, “neutrally” culturing the tissue in vitro—for example, in a petri dish with simple medium—and then observing the derivatives. If the cultured region gives rise to cell types that it would normally generate in the embryo, this means that it is specified. In contrast, determination...
The Bone Matrix01:18

The Bone Matrix

Bone contains a relatively small number of cells entrenched in a matrix of collagen fibers that provide an adherent surface for inorganic salt crystals. Both components of the matrix, organic and inorganic, contribute to the unusual properties of bone. Without collagen, bones would be brittle and shatter easily. Without mineral crystals, bones would flex and provide little support. This can be observed by an experiment: when the minerals of a bone are dissolved by soaking the bone in acid or...
Spongy Bone01:09

Spongy Bone

All bones comprise an outer layer of compact bone, and an interior made up of spongy bone tissue, also called cancellous or trabecular bone. In long bones, spongy bone tissue is mainly found in the interior of the epiphyses (broad ends of the bone).
Spongy bone is more porous, and less dense compared to compact bone. It is composed of concentric lamellae that are arranged irregularly to form the trabecular network. In some bones, the spaces between trabeculae contain red marrow, where...
Plastic Deformations of Members with a Single Plane of Symmetry01:21

Plastic Deformations of Members with a Single Plane of Symmetry

When a structural member undergoes plastic deformation due to bending, it is crucial to understand the position of the neutral axis and the stress distribution. This member, characterized by a single plane of symmetry, exhibits a uniform stress distribution, with negative stress above the neutral axis and positive stress below. Notably, the neutral axis does not align with the centroid of the cross-section. This misalignment is typical in cases where the cross-section is not rectangular or...