Model-Based Sensitivity Analysis of the Temperature in Laser Powder Bed Fusion

To quantitatively evaluate the effect of the process parameters and the material properties on the temperature in laser powder bed fusion (LPBF), this paper proposed a sensitivity analysis of the temperature based on the validated prediction model. First, three different heat source modes-point heat source, Gaussian surface heat source, and Gaussian body heat source-were introduced. Then, a case study of Ti6Al4V is conducted to determine the suitable range of heat source density for the three different heat source models. Based on this, the effects of laser processing parameters and material thermophysical parameters on the temperature field and molten pool size are quantitatively discussed based on the Gaussian surface heat source. The results indicate that the Gaussian surface heat source and the Gaussian body heat source offer higher prediction accuracy for molten pool width compared to the point heat source under similar processing parameters. When the laser energy density is between 40 and 70 J/mm³, the prediction accuracy of the Gaussian surface heat source and the body heat source is similar, and the average prediction errors are 4.427% and 2.613%, respectively. When the laser energy density is between 70 and 90 J/mm³, the prediction accuracy of the Gaussian body heat source is superior to that of the Gaussian surface heat source. Among the influencing factors, laser power exerts the greatest influence on the temperature field and molten pool size, followed by scanning speed. In particular, laser power and scan speed contribute 38.9% and 23.5% to the width of the molten pool, 39.1% and 19.6% to the depth of the molten pool, and 38.9% and 21.5% to the maximum temperature, respectively.