Experimental Investigation on the Influence of Water on Rockburst in Rock-like Material with Voids and Multiple...

To investigate the influence of water content on the rockburst phenomena in tunnels with horizontal joints, experiments were conducted on simulated rock specimens exhibiting five distinct levels of water absorption. Real-time monitoring of the entire blasting process was facilitated through a high-speed camera system, while the microscopic structure of the rockburst debris was analyzed using scanning electron microscopy (SEM) and a particle size analyzer. The experimental findings revealed that under varying degrees of water absorption, the specimens experienced three stages: debris ejection; rockburst; and debris spalling. As water content increased gradually, the intensity of rockburst in the specimens was mitigated. This was substantiated by a decline in peak stress intensity, a decrease in elastic modulus, delayed manifestation of pre-peak stress drop, enhanced amplitude, diminished elastic potential energy, and augmented dissipation energy, resulting in an expanded angle of rockburst debris ejection. With increasing water content, the bond strength between micro-particles was attenuated, resulting in the disintegration of the bonding material. Deformation failure was defined by the expansion of minuscule pores, gradual propagation of micro-cracks, augmentation of fluffy fine particles, exacerbation of structural surface damage akin to a honeycomb structure, diminishment of particle diameter, and a notable increase in quantity. Furthermore, the augmentation of secondary cracks and shear cracks, coupled with the enlargement of spalling areas, signified the escalation of deformation failure. Simultaneously, the total mass of rockburst debris gradually diminished, accompanied by a corresponding decrease in the proportion of micro and fine particles within the debris.