Related Experiment Video
Updated: May 2, 2026

Four-Dimensional CT Analysis Using Sequential 3D-3D Registration
Published on: November 23, 2019
Deep learning classification performance for diagnosing condylar osteoarthritis in patients with dentofacial
Yukiko Iwase1, Tomoya Sugiki1, Yoshitaka Kise2
1Department of Oral and Maxillofacial Radiology, Aichi Gakuin University School of Dentistry, 2-11 Suemori-Dori, Chikusa-Ku, Nagoya, 464-8651, Japan.
Objective:
The present study aimed to assess the consistencies and performances of deep learning (DL) models in the diagnosis of condylar osteoarthritis (OA) among patients with dentofacial deformities using panoramic temporomandibular joint (TMJ) projection images.
Methods:
A total of 68 TMJs with or without condylar OA in dentofacial deformity patients were tested to verify the consistencies and performances of DL models created using 252 TMJs with or without OA in TMJ disorder and dentofacial deformity patients; these models were used to diagnose OA on conventional panoramic (Con-Pa) images and open (Open-TMJ) and closed (Closed-TMJ) mouth TMJ projection images. The GoogLeNet and VGG-16 networks were used to create the DL models. For comparison, two dental residents with < 1 year of experience interpreting radiographs evaluated the same condyle data that had been used to test the DL models.
Results:
On Open-TMJ images, the DL models showed moderate to very good consistency, whereas the residents' demonstrated fair consistency on all images. The areas under the curve (AUCs) of both DL models on Con-Pa (0.84 for GoogLeNet and 0.75 for VGG-16) and Open-TMJ images (0.89 for both models) were significantly higher than the residents' AUCs (p < 0.01). The AUCs of the DL models on Open-TMJ images (0.89 for both models) were higher than the AUCs on Closed-TMJ images (0.72 for both models).
Conclusions:
The DL models created in this study could help residents to interpret Con-Pa and Open-TMJ images in the diagnosis of condylar OA.
Related Concept Videos
Classification of Bones
Long and Short Bones
The appendicular skeleton, particularly the upper and lower limbs, is primarily made of long and short bones. The...
Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An...
Imaging Studies III: Computed Tomography

