Related Experiment Video
Updated: May 12, 2026

15:47
Nanofabrication of Gate-defined GaAs/AlGaAs Lateral Quantum Dots
Published on: November 1, 2013
16.2K
Erratum: Lower Bounds on Quantum Annealing Times [Phys. Rev. Lett. 130, 140601 (2023)]
Physical Review Letters
|July 12, 2024
Abstract:
This corrects the article DOI: 10.1103/PhysRevLett.130.140601.
Related Concept Videos
Maxam-Gilbert Sequencing
In the same year as the discovery of the Sanger sequencing method, another group of scientists, Allan Maxam and Walter Gilbert, demonstrated their chemical-cleavage method for DNA sequencing. The Maxam-Gilbert method relies on using different chemicals that can cleave the DNA sequence at specific sites, the separation of resulting DNA fragments of variable size using electrophoresis, and deciphering the DNA sequence from the resulting gel bands.
Challenges of the Maxam-Gilbert Method
The...
Challenges of the Maxam-Gilbert Method
The...
Ampere's Law: Problem-Solving
Ampere's law states that for any closed looped path, the line integral of the magnetic field along the path equals the vacuum permeability times the current enclosed in the loop. If the fingers of the right hand curl along the direction of the integration path, the current in the direction of the thumb is considered positive. The current opposite to the thumb direction is considered negative.
Specific steps need to be considered while calculating the symmetric magnetic field distribution using...
Specific steps need to be considered while calculating the symmetric magnetic field distribution using...
Ampere-Maxwell's Law: Problem-Solving
A parallel-plate capacitor with capacitance C, whose plates have area A and separation distance d, is connected to a resistor R and a battery of voltage V. The current starts to flow at t = 0. What is the displacement current between the capacitor plates at time t? From the properties of the capacitor, what is the corresponding real current?
To solve the problem, we can use the equations from the analysis of an RC circuit and Maxwell's version of Ampère's law.
For the first part of the problem,...
To solve the problem, we can use the equations from the analysis of an RC circuit and Maxwell's version of Ampère's law.
For the first part of the problem,...
Limits of the First Law of Thermodynamics
Spontaneous processes, like a rock falling to the ground or sodium reacting with chlorine, occur without external work and often involve a decrease in the system‘s energy. However, certain endothermic processes, such as the dissolution of sodium chloride in water, occur spontaneously even though they increase the energy of the system. This limitation suggests that the First Law of Thermodynamics, which states that the total energy of a system is constant in an isolated system, cannot fully...
Reaction Mechanisms: Rate-limiting Step Approximation
The rate-determining step, or RDS, in a chemical reaction is the slowest step that determines the overall reaction rate. It is identified by using the observed rate law and typically involves approximation methods like the RDS approximation or the steady-state approximation.In the RDS approximation, also known as the rate-limiting-step or equilibrium approximation, the reaction mechanism consists of one or more reversible reactions near equilibrium, followed by a slower RDS, and then one or...
Calculation of First-Law Quantities II
The first law of thermodynamics establishes that the change in internal energy of a system is given by ΔU = q + w, where q is the heat exchanged, and w is the work performed. For a perfect gas, both internal energy (U) and enthalpy (H) depend solely on temperature. Consequently, for any change of state, whether reversible or irreversible, the internal energy change is determined by integrating the heat capacity at constant volume, and the enthalpy change by integrating the heat capacity at...

