Air drag controls the runout of small laboratory landslides

Abrasion resistance is an essential characteristic of concrete that determines its durability and longevity under various wear conditions. Concrete surfaces are vulnerable to different types of abrasion. For instance, surfaces may wear down due to the constant movement of vehicles or be eroded by solids carried in water, as seen in concrete canal linings. Specific tests are conducted to measure the abrasion resistance of concrete.
One such test is the revolving disc test, where three plates...

Drag is a resistive force opposing an object’s motion through a fluid, resulting from surface pressure and shear forces. It comprises two components: a perpendicular one from pressure and a tangential one from shear stress. Accurate drag calculations use pressure and wall shear stress distributions, often determined through Computational Fluid Dynamics (CFD) or wind tunnel testing. The drag coefficient, a dimensionless measure, depends on factors like shape, Reynolds number, Mach number,...

Rolling with slipping is a physical phenomenon that occurs when a rolling object experiences both rotational and linear motion but also experiences frictional forces that cause slipping. This phenomenon can occur in various situations, such as when a tire rolls on a wet road or a ball rolls on a rough surface.
An object's rolling motion is characterized by its rotation around its axis, while linear motion refers to the object's translational motion along a surface. Frictional forces can...

Rolling resistance, also known as rolling friction, is the force that resists the motion of a rolling object, such as a wheel, tire, or ball, when it moves over a surface. It is caused by the deformation of the object and the surface in contact with each other, as well as other factors like internal friction, hysteresis, and energy losses within the materials. Rolling resistance opposes the object's motion, requiring additional energy to overcome it and maintain movement. In practical...

An interesting force in everyday life is the force of drag on an object when it is moving in a fluid. Like friction, the drag force always opposes the motion of an object. Unlike simple friction, the drag force is proportional to some function of the velocity of the object in that fluid. This functionality is complicated and depends upon the shape of the object, its size, its velocity, and the fluid it is in. For most large objects, such as cyclists, cars, and baseballs, that are not moving too...

The right type and quality of aggregates are crucial for concrete as they significantly influence its properties, mix proportions, and cost-effectiveness. If different sources are available for sand, the commonly used fine aggregate in concrete, the selection of sand is primarily based on its gradation.
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...