Effect of Continuous Casting and Heat Treatment Parameters on the Microstructure and Mechanical Properties of...

The growing use of aluminum and its compounds has increased the volume of aluminum waste. To mitigate environmental impacts and cut down on manufacturing expenses, extensive investigations have recently been undertaken to recycle aluminum compounds. This paper outlines the outcomes of a study on fabricating standard EN AW-2007 alloy using industrial and secondary scrap through continuous casting. The resultant recycled bars were analyzed for their chemical makeup and examined for microstructural features in both the cast and T4 states, undergoing mechanical property evaluations. The study identified several phases in the cast form through LM, SEM + EDS, and XRD techniques: Al₇Cu₂Fe, θ-Al₂Cu, β-Mg₂Si, Q-Al₄Cu₂Mg₈Si₇, and α-Al₁₅(FeMn)₃ (SiCu)_2, along with Pb particles. Most primary intermetallic precipitates such as θ-Al₂Cu, β-Mg₂Si, and Q-Al₄Cu₂Mg₈Si₇ dissolved into the α-Al solid solution during the solution heat treatment. In the subsequent natural aging process, the θ-Al₂Cu phase predominantly emerged as a finely dispersed hardening phase. The peak hardness achieved in the EN AW-2007 alloy was 124.8 HB, following a solution heat treatment at 500 °C and aging at 25 °C for 80 h. The static tensile test assessed the mechanical and ductility properties of the EN AW-2007 alloy in both the cast and T4 heat-treated states. Superior strength parameters were achieved after solution heat treatment at 500 °C for 6 h, followed by water quenching and natural aging at 25 °C/9 h, with a tensile strength of 435.0 MPa, a yield strength of 240.5 MPa, and an appreciable elongation of 18.1% at break. The findings demonstrate the feasibility of producing defect-free EN AW-2007 alloy ingots with excellent mechanical properties from recycled scrap using the continuous casting technique.