Position-Specific Oxygen Isotope Analysis in Inositol Phosphates by Using Electrospray Ionization-Quadrupole-Orbitrap...

Conventional isotope-ratio mass spectrometry measurements obscure position-specific isotope distributions in molecular compounds because these measurements require an initial step that converts compounds into simple gases by combustion or pyrolysis. Here, we used electrospray ionization (ESI)-based Orbitrap mass spectrometry to measure oxygen isotope ratios in the phosphate and hydroxyl moieties of inositol phosphates. A thermal hydrolysis experiment was conducted using ¹⁸O-labeled water to examine the position-specific oxygen isotope exchange in inositol hexakisphosphate (IP₆) as well as its hydrolysis products IP₅, IP₃, and PO₃ fragments. Measurement precisions of the position-specific and molecular-average oxygen isotope values of inositol phosphates were better than ±1.1‰ and ±0.5‰, respectively. Under optimized ionization and Orbitrap parameters, this level of precision was obtained within 30 min of run time at 60 μM initial concentration of inositol phosphate. The ability to measure phosphate-specific oxygen isotopes in inositol phosphate enabled the quantification of isotope exchange, which did not occur in phosphate on IP₆, IP₅, IP₃, and PO₃ fragments, meaning that the change in isotopes should have resulted from hydroxyls in the ring. Isotope mass balance calculations corroborated that hydroxyl oxygens are derived from ¹⁸O-labeled water. With the observed sensitivity and precision achieved in this study, Orbitrap IRMS proved to be a promising tool for investigating the position-specific oxygen isotopes in organophosphorus compounds. These outcomes open up numerous potential applications that can expand our understanding of phosphorus cycling in the environment.