High-Efficiency High-Temperature-Resistant Nanosilica Viscosity Reducer for Extra-Heavy Oil Viscosity Reduction

Due to the fact that more conventional heavy oil recovery methods (heating, emulsification, dilution, and other methods) have many shortcomings, they cannot meet the demand of heavy oil exploitation. Therefore, there is a need for new recovery methods. In this paper, the surface of nano SiO₂ was modified with a silane coupling agent, KH-560, to prepare a nanoviscosity reducer (NRV), which has high-temperature resistance (300 °C), calcium and magnesium resistance (Ca²⁺ + Mg²⁺ > 900 mg/L) and high viscosity reduction rate (>99%). FTIR and SEM measurements showed that KH560 has been successfully connected to the surface of SiO₂. The particle size distribution of NRV is mainly distributed in 50-80 nm, which matches the results of SEM. The experimental results showed that the viscosity reduction rates of 1 wt % NRV on M-1 heavy oil before and after aging were 99.73% and 99.71%, respectively. The viscosity reduction effect of 1% NRV on M-1 heavy oil and the bleeding rate of emulsion formation were investigated when the oil-water ratio ranged from 9:1 to 1:9. The results showed that when the oil-water ratio was between 7:3 and 1:9, the viscosity reduction rate was greater than 99%. Besides, the bleeding rate of emulsion increases with the decrease of the oil-water ratio. What's more, static and dynamic adsorption experiments showed that the adsorption capacity of 1 wt % NRV was 1.746 mg/g and 1.668 mg/g sand, respectively. The interfacial tension experiment showed that the interfacial tension (IFT) between 1 wt % NRV and M-1 heavy oil was 0.052 mN/m, and low interfacial tension was beneficial to displace the oil in the formation pores. At the same time, the displacement effect of NRV on M-1 heavy oil at different concentrations (0.5, 1.0, and 1.5 wt %) and temperatures (200, 250, and 300 °C) was investigated by core flooding experiments. The results showed that the recovery rate increases with the increase of NRV concentration, and 1 wt % NRV at 300 °C will improve the recovery rate of M-1 heavy oil by 27.3% compared to steam flooding. NRV could reduce the viscosity of crude oil, which provides technical guidelines for the exploitation of heavy oil and extra heavy oil.