Effects of Using Laser Technology for Cutting Polymer Films

In connection with the need to obtain a properly made and cut material and the appearance of the surface layer, new manufacturing technologies were used for tests, namely the laser cutting technology. This article describes the laboratory stand built for the purpose of research, as well as the possibility of using laser cutting on several sample materials (polymer films), together with an indication of the results obtained. The idea was to elaborate on the cutting technology that will be proper for manufacturing the desired type of spacers for ion-exchange membranes separating while maintaining the required level of product quality and chemical purity. The latter criterion was the basic one, due to the scope of use of the manufactured elements. This article also describes the problem encountered during the construction of the stand or during the research. The last part of this article describes the further steps of the research that will be carried out in the future along with a discussion and summary of the research performed. It is important from the point of view of the development of production technology, but also because of the characteristics of materials for the production of surface layers and coatings resistant to mechanical or thermal wear used in industry. The introduction of innovative solutions is also aimed at studying the improvement of the economics of the production of materials that are significant, in particular, for small- and medium-sized enterprises.