A Comparative Evaluation of Surface Hardness and Nanomechanical Properties of Nickel-Titanium Orthodontic Wires: An...

The study aimed to evaluate the influence of various surface coatings (epoxy, Teflon, and rhodium) on the surface roughness (SR) and nanomechanical characteristics of nickel-titanium (NiTi) archwires. The study compared these coated archwires to uncoated ones from a single manufacturer, which served as a control.

There were 15 rectangular samples of four distinct archwires measuring 0.17 × 0.25. These were ultrasonically treated with an alkaline solution at 60°C for 15 minutes before being rinsed with distilled water to remove precipitates. With an orthodontic soft wire cutter, the straight buccal sections of coated and uncoated archwires were cut into 20 mm lengths. A three-dimensional optical noncontact surface profilometer evaluated the surface. Profilometers use contact scanning white light interferometry. Using the Vision64 software (Bruker Corporation, San Jose, CA), the profilometer's nanolens atomic force microscopy module has a completely automated turret with programmed X, Y, and Z motions. Images were taken in five random locations. Five average measurements matched specimen SR. A nanoindenter with a Berkovich diamond indenter measured nanohardness (NH) and elastic modulus (EM). The experimental results were analyzed using the Statistical Package for the Social Sciences software version 26.0 (SPSS Inc., Chicago, IL). To examine mean differences at 5% significance, analysis of variance and Tukey's post hoc test were applied for SR, NH, and EM.

Wires coated with epoxy had the highest SR (1.499 ± 0.082), followed by Teflon (0.811 ± 0.023) and rhodium (0.308 ± 0.024). The SR of the control group was 0.289 ± 0.027. Significant differences in SR were found (p < 0.0001). Except for the comparison between rhodium and the control group (p = 0.684), all intergroup comparisons of SR showed significant differences (p < 0.0001). The rhodium-coated wires exhibited the highest NH (0.185 ± 0.014), and the epoxy group had the lowest (0.147 ± 0.017). Variations in NH were significant between the study groups (p < 0.0001). The epoxy, Teflon, and rhodium groups showed significant differences against the control group (p < 0.0001) in intergroup comparisons for NH. The Teflon group had the highest EM (5.367 ± 0.379), and the epoxy group had the lowest (5.012 ± 0.498). The EM of the control group was 56.946 ± 0.737. Results indicate considerable EM changes between the groups (p < 0.05). Comparisons between experimental and control groups showed significant differences (p < 0.0001).

The study's findings indicate that the SR of rhodium-coated archwires is substantially comparable to that of uncoated archwires. However, Teflon-, rhodium-, and epoxy-coated archwires had significantly different NH and EM compared to uncoated ones. Further, uncoated archwires have higher NH and EM.