Optimization of polymer coating thickness and strut width in drug Eluting stents using Magnetic field

The transport of drug/magnetic particle (MP) conjugates in the presence of a Magnetic Field (MF) in Drug Eluting Stents (DESs) is modeled numerically using the Finite Volume Method (FVM). The effects of physiological conditions corresponding to different degrees of calcification, drug particles sizes and hematocrit level, were analyzed by investigating the roles of the tissue permeability, its anisotropy and the plasma viscosity. It was found that both in the absence and presence of the MF, as the tissue permeability decreases or the plasma viscosity increases, the free-phase drug and Extracellular Matrix (ECM)-bound phase contents increase. Stronger tissue anisotropy leads to a decrease of the free-phase drug content and an increase of the ECM-bound phase content. Within the explored ranges, the Specific Receptor (SR)-bound phase of the drug was found to be insensitive to the tissue permeability and plasma viscosity, and to be larger in anisotropic tissues. The activation of the MF leads systematically to larger free-phase drug contents, with the increases most prominent at smaller tissue permeability, anisotropy and plasma viscosity. On the other hand, the effects on the ECM-bound phase content are found to be stronger at larger permeability, smaller plasma viscosity and lower tissue anisotropy. For an isotropic tissue, the MF induces a decrease of the ECM-bound phase content at early times, followed by an increase at later times. For the considered ranges of permeability and viscosity, the MF does not seem to have any noticeable effects on the SR-bound phase. However, this phase of the drug tends to increase with the activation of the MF in isotropic tissues and is unchanged in anisotropic ones. These reported effects of the MF hold promise for alleviating two factors contributing to In-Stent Restenosis, namely the polymer coating width and thickness. The study reveals that a narrower or thinner polymer layer, in combination with the MF, can mimic the drug release dynamics of a wider or thicker polymer layer in the absence of the MF. The corresponding width and thickness of the magnetized stents, that we referred to as the equivalent polymer width (EPW) and equivalent polymer thickness (EPT) were determined and their dependence on the tissue permeability, isotropy and the plasma viscosity, was investigated. The study shows that it is possible to achieve the same drug delivery with polymer coating of half the width or half the thickness of the non-magnetized stent when an electric intensity of 3A is used.