Dynamics and synchronization control of fractional conformable neuron system

Dynamic analysis, electrical coupling and synchronization control of the conformable FitzHugh-Nagumo neuronal models have been presented in this work. Firstly, equations of the Adomian-Decomposition-Method and conformable neuron model have been introduced. The Adomian-Decomposition-Method has been employed for the numerical simulation analysis, since it converges fast and provides serial solutions. Fractional order and external current stimulus have been considered as bifurcation parameters and their effects on neuron model dynamics have been examined in detail. Then, the electrical coupling of the two conformable neuronal models without any controller has been revealed and the significance of the coupling strength parameter has been evaluated. To eliminate impact of the coupling strength parameter on synchronization status of neurons, Lyapunov control method has been employed for synchronization control. In the last step, the numerical simulation studies have been experimentally verified using the Texas Instrument Delfino digital signal processor board. Numerical simulation results together with experimental validation have showed that the types of dynamics of the related neuron model are not affected from the change of the fractional order of conformable derivative, but the frequency of the dynamic response of the neuronal model is changed from the alteration of the fractional order. The frequency of response of the neuron model increases with decreasing values of the fractional order. On the other hand, if there is no synchronization control method, the coupled neuron models exhibit response ranging from synchronous to asynchronous depending on the sign and value of the coupling parameter. Additionally, decreasing values of the fractional order may allow the coupled neurons to enter the synchronous state more quickly due to increasing frequency of response of the neuronal model. Finally, the coupled neuron models could exhibit synchronous behavior, that is determined by calculating the standard deviation results, regardless of the value of the coupling parameter by using the Lyapunov control method.