Lipid loss and compositional change during preparation of simple two-component liposomes

Liposomes are used as model membranes in many scientific fields. Various methods exist to prepare liposomes, but common procedures include thin-film hydration followed by extrusion, freeze-thaw, and/or sonication. These procedures can produce liposomes at specific concentrations and lipid compositions, and researchers often assume that the concentration and composition of their liposomes are similar or identical to what would be expected if no lipid loss occurred. However, lipid loss and concomitant biasing of lipid composition can in principle occur at any preparation step due to nonideal mixing, lipid-surface interactions, etc. Here, we report a straightforward HPLC-ELSD method to quantify the lipid concentration and composition of liposomes and apply that method to study the preparation of simple cholesterol/POPC liposomes. We examine common liposome preparation steps, including vortexing during resuspension, lipid film hydration, extrusion, freeze-thaw, and sonication. We found that the resuspension step can play an outsized role in determining the lipid loss (up to ∼50% under seemingly rigorous procedures). The extrusion step yielded smaller lipid losses (∼10-20%). Freeze-thaw and sonication could both be employed to improve lipid yields. Hydration times up to 60 min and increasing cholesterol concentrations up to 50 mol % had little influence on lipid recovery. Fortunately, even conditions with large lipid loss did not substantially influence the target membrane composition, as long as the lipid mixture was below the cholesterol solubility limit. From our results, we identify best practices for producing maximum levels of lipid recovery and minimal changes to lipid composition during liposome preparation for cholesterol/POPC liposomes.