Related Experiment Video
Updated: Jun 14, 2025
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
Evaluating the Effectiveness of the "Double Finish Line Technique" on Full-Crown Retention for Short Abutments: An In
Salam Jalal Aljabr1, Mohammad Luai Morad1, Mohammad Y Hajeer2
1Department of Fixed Prosthodontics, Faculty of Dentistry, University of Damascus, Damascus, SYR.
Background:
Achieving clinically adequate retention for cast crowns in prepared short abutments represents a major challenge for practicing dentists. Despite the important developments with adhesive cement, only a few teeth can be treated this way, and conventional preparation techniques are still employed for most crowns. Numerous options for auxiliary features exist; however, there is no consensus about one preferred method. This study aimed to evaluate the effect of a new innovative technique called the "double finish line technique" on full-crown retention for short abutments and to compare it with another modified preparation method.
Material And Methods:
A comparative in vitro experimental study was conducted at the Department of Fixed Prosthodontics, Damascus University. The study sample consisted of 30 chromium-cobalt abutments and 30 metal crowns. The sample was divided into three equal groups. The first group was a control group (CG) with a 20-degree total occlusal convergence, 3 mm height, and a 0.5 mm chamfer finish line. The second group had a reduced total occlusal convergence (TOC) in the cervical 1.5 mm of the axial wall from 20 to 8 degrees. The third group implemented the so-called "double finish line technique," adding another 0.5 mm chamfer finish line 1 mm above the first finish line (DFL group). The metal crowns were cemented to metal dies with zinc-phosphate cement. Pull-off tests were applied until failure. Data were analyzed, and the differences between the three groups were detected using one-way ANOVA followed by Bonferroni's post-hoc tests (p<0.05).
Results:
The mean tensile strength values for the specimens were 115.36 (SD=14.59), 149.60 (SD=11.10), and 42.46 (SD=11.54) for the TOC, DFL, and CR groups, respectively.
Conclusion:
The reduced total occlusal convergence and double finish line techniques effectively increased full crown retention and resistance cemented on short abutments.
