Combustion visualization analysis of alternative fuels in the pulverized coal injection raceway through laminar flow...

Currently, the steelmaking process uses a pulverized coal injection (PCI) system that serves as the heat source and reductant for ironmaking (blast furnace and FINEX) where system uses expensive high-grade coal and high operating costs. Hydrogen steelmaking is currently being developed to achieve carbon-free operation. To achieve a soft-landing during this phase of rapid change, the use of biomass and inexpensive, thermal coal, and coke dust is necessary. Research on their combustion characteristics is necessary to apply these alternative fuels to PCI. Therefore, this study analyzed the combustion characteristics of ignition delay, devolatilization, and char combustion using a laminar flow reactor visualization equipment that simulates blast furnace (BF) and FINEX PCI tuyere, using flame image data processing. The ignition time were generally longer in BF than in FINEX, and the char combustion length and time also showed the same trend due to the high oxygen rate which indicate under 2 ms on ignition delay, under 16 ms on char combustion. Also, the volatile cloud was qualitatively shown in the image to be highest in thermal coal and biomass with high volatile matter. Based on the correlation and theoretical calculation with proximate analysis and the results, ignition delay time had a combined effect of volatile matter and moisture except coke dust, and char combustion time affected unburned carbon. The combustion chemical characteristics were discussed with chemical percolation devolatilization (CPD) model parameter. Through SEM image and BET analysis, the surface area has been increased more than 10 times after combustion. Consequently, the biomass and high moisture thermal coal could cofired within 10 % and coke dust could be cofired within 9 %, respectively.