Research on Adaptive Closed-Loop Control of Microelectromechanical System Gyroscopes under Temperature Disturbance

Microelectromechanical System (MEMS) gyroscopes are inertial sensors used to measure angular velocity. Due to their small size and low power consumption, MEMS devices are widely employed in consumer electronics and the automotive industry. MEMS gyroscopes typically use closed-loop control systems, which often use PID controllers with fixed parameters. These classical PID controllers require a trade-off between overshoot and rise time. However, temperature variations can cause changes in the gyroscope's parameters, which in turn affect the PID controller's performance. To address this issue, this paper proposes an adaptive PID controller that adjusts its parameters in response to temperature-induced changes in the gyroscope's characteristics, based on the error value. A closed-loop control system using the adaptive PID was developed in Simulink and compared with a classical PID controller. The results demonstrate that the adaptive PID controller effectively tracked the changes in the gyroscope's parameters, reducing overshoot by 96% while maintaining a similar rise time. During gyroscope startup, the adaptive PID controller achieves faster stabilization with a 0.036 s settling time, outperforming the 0.06 s of the conventional PID controller.