A Micromachined Silicon-on-Glass Accelerometer with an Optimized Comb Finger Gap Arrangement

This paper reports the design, fabrication, and characterization of a MEMS capacitive accelerometer with an asymmetrical comb finger arrangement. By optimizing the ratio of the gaps of a rotor finger to its two adjacent stator fingers, the sensitivity of the accelerometer is maximized for the same comb finger area. With the fingers' length, width, and depth at 120 μm, 4 μm, and 45 μm, respectively, the optimized finger gap ratio is 2.5. The area of the proof mass is 750 μm × 560 μm, which leads to a theoretical thermomechanical noise of 9 μg/√Hz. The accelerometer has been fabricated using a modified silicon-on-glass (SOG) process, in which a groove is pre-etched into the glass to hold the metal electrode. This SOG process greatly improves the silicon-to-glass bonding yield. The measurement results show that the resonant frequency of the accelerometer is about 2.05 kHz, the noise floor is 28 μg/√Hz, and the nonlinearity is less than 0.5%.