Optimization, Formulation, and Ex vivo Evaluation of Solid Lipid Nanoparticles for Transdermal Delivery of Diltiazem...

Cardiac arrhythmia, is a medical condition that reduces the heart's efficiency in pumping blood, and can be fatal, requires long-term management with conventional drugs, despite their limited efficacy. Diltiazem hydrochloride, chosen as a model drug, has a short biological half-life and extensive metabolism. Administering drug through skin is challenging, particularly due to the penetration via stratum corneum. However, solid lipid nanoparticles as a particulate carrier system can enhance its permeation and bioavailability.

The study aimed to develop a matrix type transdermal patch with diltiazem hydrochloride encapsulated in solid lipid nanoparticles.

The study used the solvent diffusion technique to prepare SLNs by mixing the drug and solid lipid in an organic phase at 80°C, then slowly adding it to an aqueous phase with continuous stirring for 45 minutes. The resulting nanodispersion was freeze-dried and analyzed for morphological studies, encapsulation efficiency & drug content. A patch was formulated using solvent evaporation technique, incorporating HPMC E50 (2% w/v), propylene glycol, and ethanolic oleic acid (1.5% v/v). SLNs loaded with diltiazem hydrochloride taken equivalent to diltiazem hydrochloride dose in the transdermal patch. The patch was then evaluated for In vitro and skin permeation studies.

The result showed a positive correlation between lipid concentration and particle size. Probe sonication and homogenization increased particle size, while stirring speed reduced it. SEM and TEM images confirmed spherical particles with a size of 488.1±4.01nm and an entrapment efficiency of 55.03±1.99%. Drug release studies demonstrated 70.7% drug release from lipid matrix over 24 hrs. The formulated patch with uniform SLN distribution, had a drug content 89.37 ± 0.04% with a surface pH of 6.1 ± 0.53, close to skin pH. The uniformity of content in 3x3 patch estimated to be 14.587 ± 1.404 mg, close to the theoretical content 16.318 ± 1.08 mg, confirmed homogenous distribution of diltiazem hydrochloride SLNs throughout the patch diameter. Cumulative amount released from patch formulation at pH 5.6 and pH 7.4 was 518.1414μg/cm² and 404.4466 μg/cm². Synergistic flux enhancement was observed with oleic acid propylene glycol blend. Ex vivo study of the patch showed steady-state flux of 6.9 μg/cm2/hr, permeability coefficient 0.00362 cm/hr, diffusion coefficient 0.000103 cm/hr, cumulative drug permeation (Dmax) 814.885 μg after 24 hrs, and followed a Higuchi-matrix release model.

The developed patch possessed improved bioavailability with reduced dosing and enhanced patient compliance.