Design, Calibration and Morphological Characterization of a Flexible Sensor with Adjustable Chemical Sensitivity and...

Active life monitoring via chemosensitive sensors could hold promise for enhancing athlete monitoring, training optimization, and performance in athletes. The present work investigates a resistive flex sensor (RFS) in the guise of a chemical sensor. Its carbon 'texture' has shown to be sensitive to CO₂, O₂, and RH changes; moreover, different bending conditions can modulate its sensitivity and selectivity for these gases and vapors. A three-step feasibility study is presented including: design and fabrication of the electronic read-out and control; calibration of the sensors to CO₂, O₂ and RH; and a morphological study of the material when interacting with the gas and vapor molecules. The 0.1 mm^-1 curvature performs best among the tested configurations. It shows a linear response curve for each gas, the ranges of concentrations are adequate, and the sensitivity is good for all gases. The curvature can be modulated during data acquisition to tailor the sensitivity and selectivity for a specific gas. In particular, good results have been obtained with a curvature of 0.1 mm^-1. For O₂ in the range of 20-70%, the sensor has a sensitivity of 0.7 mV/%. For CO₂ in the range of 4-80%, the sensitivity is 3.7 mV/%, and for RH the sensitivity is 33 mV/%. Additionally, a working principle, based on observation via scanning electron microscopy, has been proposed to explain the chemical sensing potential of this sensor. Bending seems to enlarge the cracks present in the RFS coverage; this change accounts for the altered selectivity depending on the sensor's curvature. Further studies are needed to confirm result's reliability and the correctness of the interpretation.