Dynamic mechanical characteristics of coal in front of the mining face under different mining layouts

To study the dynamic mechanical characteristics of coal in the area affected by mining in front of the mining face under different mining methods, an improved split Hopkinson pressure bar (SHPB) was used to apply different static loads to different positions. Then, dynamic mechanical tests were conducted on coal at different positions on the mining face, analyzing the dynamic response under strong dynamic load disturbances, under three different mining layouts. Within the range of static water pressure to the peak support pressure, the dynamic strength of coal gradually increases with increasing distance from the mining face. The dynamic strength is the smallest at the peak support pressure stress, and under strong external disturbances, instability and failure are increasingly likely to occur at the peak stress. Under the same loading rate conditions, the dynamic strength of the peak stress in coal is as follows: Protective coal-seam mining (PCM) > Top-coal caving mining (TCM) > Nonpillar mining (NM).