[Pollution Characteristics, Risk Assessment, and Source Analysis of Heavy Metals in Soil from a Typical Abandoned...

Considering the surface soil （0-20 cm） from a typical abandoned antimony smelting factory area in Dachang Town, Qinglong County, Guizhou Province, as a case study, a total of 14 soil samples were systematically collected from both within and outside the smelting factory area. The analysis focused on the pollution status, distribution characteristics, and potential ecological risks of heavy metals such as Sb, As, Cd, Cr, Pb, Cu, Zn, Ni, and V in the soil. Additionally, an evaluation and analysis of pollution sources were conducted. The results showed that the mean concentrations of heavy metals including ω（Sb）, ω（As）, ω（Cd）, ω（Cr）, ω（Pb）, ω（Cu）, ω（Zn）, ω（Ni）, and ω（V） in the surface soil of the abandoned antimony smelting factory ranged from 4.58 to 15 049.33 mg·kg^-1. With the exception of Cr and Ni, all values exceeded the background values of soils in Guizhou province. The single factor pollution indices of Sb and As were 83.61 and 7.01, respectively, indicating severe contamination. In contrast, Pb fell within the non-polluted to slightly polluted range. The comprehensive potential ecological risk of soil heavy metals was characterized by severe potential ecological risk levels for Sb, As, and Cd, while the remaining heavy metals fell within a range of moderate to substantial potential ecological risk levels. The assessment of the geoaccumulation index revealed that the soil in the study area was primarily contaminated by Sb and As, predominantly exhibiting contamination levels ranging from moderate to severe. The results from the RAC method suggested that Sb was the dominant focus for remediation in this abandoned smelting factory. The two primary pollutants, Sb and As, exhibited elevated levels in leachate toxicity, acid-soluble fraction, available fraction, gastric phase, and intestinal phase in terms of bioavailable content, indicating a certain potential hazard. Further, correlation analysis indicated a certain correlation between the total amount of heavy metals and leachate toxicity, available fraction, acid-soluble fraction, reducible fraction, oxidizable fraction, gastric phase extractable fraction, and intestinal phase extractable fraction. The APCS-MLR model indicated that the sources of Sb, As, Zn, Cu, and Cd were primarily industrial, while the sources of Cr and V were mainly natural, and Pb originated mainly from mixed sources.