Related Experiment Video
Updated: Jun 9, 2025

Additive Manufacturing-Enabled Low-Cost Particle Detector
Published on: March 24, 2023
Use of Low-Cost Sensors to Study Atmospheric Particulate Matter Concentrations: Limitations and Benefits Discussed
Filippo Brugnone1, Luciana Randazzo1,2, Sergio Calabrese1,2
1Dipartimento di Scienze della Terra e del Mare, Università degli Studi di Palermo, Via Archirafi, 36, 90123 Palermo, Italy.
Abstract:
The paper discusses the results of the concentrations of atmospheric particulate matter, in the PM2.5 and PM10 fractions, acquired by two low-cost sensors. The research was carried out from 1 July 2023 to 30 June 2024, in Palermo, Sicily. The results obtained from two systems equipped with the same sensor model were compared. Excellent linear correlation was observed between the results, with differences in measurements falling within instrumental accuracy. Two instruments equipped with different sensors, models Novasense SDS011 and Plantower PMSA003, were placed at the same site. These were complemented by a weather station to measure meteorological parameters. Upon comparing the atmospheric particulate matter concentrations measured by the two instruments, it was observed that there was a good linear correlation for PM2.5 and a poor linear correlation for PM10. Additionally, the PMSA003 sensor appeared to consistently record higher concentrations than the SDS011 sensor. During periods influenced by natural sources and/or anthropogenic activities at the regional and/or local scale, i.e., the dispersal of Saharan sands, forest fires, and local events using fireworks, abnormal concentrations of atmospheric particulate matter were detected. Despite the inherent limitations in precision and accuracy, both low-cost instruments were able to identify periods with abnormal concentrations of atmospheric particulate matter, regardless of their source or type.
More Related Videos
08:59Measuring Sub-23 Nanometer Real Driving Particle Number Emissions Using the Portable DownToTen Sampling System
Published on: May 22, 2020
07:47Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016