Related Experiment Video
Updated: Aug 19, 2026

Multiplex Therapeutic Drug Monitoring by Isotope-dilution HPLC-MS/MS of Antibiotics in Critical Illnesses
Published on: August 30, 2018
Protein binding and pharmacokinetics of lincomycin following intravenous administration of high doses
Abstract:
High-dose infusions of lincomycin 600, 1,200, and 2,400 mg were administered to 14 healthy, adult men. Using model-independent pharmacokinetics, it was found that the half-life, mean residence time, and steady-state volume of distribution of total drug increased with dose, whereas the same parameters remained unchanged for the unbound lincomycin. Although the mean clearance value for total drug increased, this change fell short of being significant at the 5% level and was associated with a decrease in unbound clearance following administration of the 2,400 mg dose. Protein binding studies using ultrafiltration gave direct evidence of saturable serum protein binding and indicated that binding involved at least two distinct classes of binding sites.
More Related Videos
Related Concept Videos
Drug Distribution: Tissue Binding
For...
Drug Distribution: Plasma Protein Binding
Tissue-Drug Binding: Localization of Drugs and its Significance
Drugs can bind to different tissue components, enhancing their distribution and localization. The factors influencing drug localization in tissues include the drug's lipophilicity, structural characteristics, tissue perfusion rate, and pH differences. These factors determine the...
Nonlinear Pharmacokinetics: Overview
Nonlinearity can arise due to the saturation of plasma protein-binding or...
Nonlinear Pharmacokinetics: Causes of Nonlinearity
Nonlinear drug absorption can occur when the process is rate-limited by solubility, carrier-mediated transport systems, or saturation of the presystemic gut wall or hepatic metabolism. For instance, high doses of riboflavin...
Nonlinear Pharmacokinetics: Bioavailability and Protein-Drug Binding
To quantify the extent of bioavailability, pharmacologists often use a parameter called .

