Related Experiment Video
Updated: Jun 7, 2025

Resonance Raman Spectroscopy of Extreme Nanowires and Other 1D Systems
Published on: April 28, 2016
Nontrivial Raman Characteristics in 2D Non-Van der Waals Mo5N6
Ching-Hsiang Yao1, Hongze Gao1, Lu Ping1
1Department of Chemistry, Boston University, Boston, Massachusetts 02215, United States.
Abstract:
Resonant Raman spectra of a two-dimensional (2D) non-van der Waals (vdW) material, molybdenum nitride (Mo5N6), are measured across varying thicknesses, ranging from a few to tens of nanometers. Fifteen distinct Raman peaks are observed experimentally, and their assignments are made using first-principles calculations for the most stable AABB-stacking structure of Mo5N6. The assignments are further supported by angular-dependent Raman measurements for all peaks, except the most intense one at 215 cm-1. Calculations reveal that the 215 cm-1 peak does not appear for three-dimensional molybdenum nitrides and is not a first-order Raman-active mode. We further investigated the origin of the 215 cm-1 peak and assigned it as a defect-induced double-resonance peak. Moreover, thickness-dependent Raman measurements reveal that both the 215 and 540 cm-1 peaks─assigned to out-of-plane and in-plane modes, respectively─blue shift as thickness increases, reaching a plateau around 20 nm. This thickness-dependent Raman shift over a wide thickness range is nontrivial compared to other common vdW 2D materials and is attributed to the much stronger stacking interaction between the constituent layers in non-vdW materials. This finding highlights Raman spectroscopy as a valuable tool for characterizing the thickness of 2D non-vdW materials.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Van der Waals Equation
First, the attractive forces between molecules, which are stronger at higher densities and reduce the pressure, are considered by adding to the pressure a term equal to the square of the molar density multiplied by a positive coefficient a. Second, the volume...
Van der Waals Interactions
Radicals: Electronic Structure and Geometry
Accordingly, the structure of a trivalent radical lies between the geometries of carbocations and carbanions. An sp2-hybridized carbocation is trigonal planar, while an sp3-hybridized carbanion is trigonal pyramidal. Here, the difference in geometry is...
¹H NMR: Complex Splitting
Splitting diagrams or splitting tree diagrams are routinely used to depict such complex couplings. While drawing splitting diagrams, the splitting with the larger coupling constant is usually applied...

