Bio-based polylactic acid labware as a sustainable alternative for microbial cultivation in life science laboratories

Single-use plastics (SUPs) in life science laboratories account for approximately 5.5 million tonnes of waste per year globally. Of SUPs used in life science laboratories, Petri dishes, centrifuge tubes, and inoculation loops are some of the most common. In order to reduce the reliance on petrochemical-based SUPs in the life science research laboratory and minimize the negative environmental impacts associated with SUPs, this research investigates the applicability of polylactic acid (PLA) in single-use labware as a replacement for petrochemical-based plastics. PLA is one of the most well-studied biodegradable plastics that can be produced from sustainable resources. Commercially available PLA was used to 3D print a select range of labware to test the suitability of PLA-based material for routine microbiology work. An injection moulded PLA-based Petri dish was also designed and produced, for increased optical clarity. The biocompatibility was tested against Gram-negative (Escherichia coli) and Gram-positive (Staphylococcus epidermidis) strains of bacteria. The PLA-based labware did not negatively impact the cell growth, viability, and metabolic activity of the bacterial cultures. The injection moulded PLA Petri dish showed a reduced colony forming unit count for the Gram-negative E. coli strain compared to the polystyrene Petri dish, ∼1.5 × 10⁹ CFU/mL and ∼3.0 × 10⁹ CFU/mL respectively, during late-exponential growth. The colony counts were, however, in the same order of magnitude. This observed difference may be due to the internal environment inside the Petri dish, hence the internal O₂ concentration, humidity, and temperature during bacterial growth were investigated. This work demonstrates, for the first time, a full successful workflow of bacterial growth using a sustainable bioplastic, providing a pathway to reducing the environmental impacts of SUPs in life science laboratories.