Related Experiment Video
Updated: Jun 6, 2025

Twin-Screw Extrusion Process to Produce Renewable Fiberboards
Published on: January 27, 2021
An Assessment of the Strength and Physical Properties of Edible Tableware from Flax Seed and Flaxseed Cake
Dariusz Andrejko1, Agata Blicharz-Kania1
1Department of Biological Bases of Food and Feed Technologies, University of Life Sciences in Lublin, Głeboka 28, 20-612 Lublin, Poland.
Abstract:
Alternatives to traditional disposable plastic tableware are constantly sought. The aim of the study was to assess the possibility of using oilseeds and their press cakes for the production of edible tableware. Edible vegan plates (P) and bowls (B) were produced. The basic ingredients used for production were flax seeds (S) or flax press cake (C). Plates made using press cakes under a pressure of 3 kg deformed to a lesser extent than those containing seeds. However, they were more susceptible to crumbling during shaking. The colour of the tableware made on the basis of flax press cakes was lighter and was characterised by a higher chromaticity in the yellow and red direction. Significantly higher water absorption was characteristic of the tableware in which flax press cakes were used instead of flax seeds. The lowest water absorption (17.14%) after 30 min of soaking was recorded for the PS sample. After the test simulating the use of the tableware, a significant reduction in strength was observed overall (except for the PS test). The panelists rated the consistency and palatability of the PS, BS and PC tests very similarly. The highest overall acceptability was noted for the BS and PC tests. In conclusion, the development of edible bowls and plates made from flax seeds or flaxseed cake is an alternative solution for the production of environmentally friendly tableware.
More Related Videos
10:18Author Spotlight: Exploring Seaweed's Bioactive Compounds for Sustainable Innovations in Industries
Published on: November 21, 2023
07:06Wicking Tests for Unidirectional Fabrics: Measurements of Capillary Parameters to Evaluate Capillary Pressure in Liquid Composite Molding Processes
Published on: January 27, 2017
Related Concept Videos
Fineness Modulus
Consider performing sieve analysis on sand through a set of ASTM sieves. The weight of aggregate retained in each sieve and pan placed at the bottom is recorded, as given in Column B of Table 1.
To determine the fineness modulus of...
Flow Table Test
Concrete is placed within a truncated cone mold that is 8 inches high with an 8-inch base diameter and a 5-inch top diameter. The...