Recyclable and non-recyclable packaging films with different barrier properties: Effect of processing and storage time on quality of mashed potato and ground carrot
Related Experiment Video
Updated: Jun 25, 2026

Isolation of Native Soil Microorganisms with Potential for Breaking Down Biodegradable Plastic Mulch Films Used in Agriculture
Published on: May 10, 2013
Nusrat Sharmin1, Bjørn Tore Rotabakk2, Magnhild Seim Grøvlen1
1Department of Food Safety and Quality, Nofima - Norwegian Institute of Food, Fisheries and Aquaculture Research, Ås, Norway.
Abstract:
The aim of this study was to evaluate if high barrier recyclable material polyethylene/ethylene vinyl alcohol (PE/EVOH) can be an alternative non-recyclable polyamides (PA)/PE laminate and also if high barrier is required or recyclable PE material with low barrier properties is good enough to maintain the quality of thermally processed mashed potato and ground carrot. The oxygen transmission rate (OTR) of the PA/PE and PE films decreased after heat treatment, while no change was observed for PE/EVOH films. Food contact did not impact the OTR of PA/PE and PE/EVOH films, while the OTR of PE films decreased. The water vapor transmission rate (WVTR) of PA/PE and PE/EVOH films increased after heat treatment. In general, the WVTR of films increased after food contact. The tensile strength of all films was only reduced up to 3-4 weeks of food contact. After 10 weeks, the PE film showed significantly lower hue values and a larger total color difference than the two other films. Light exposure reduced the hue values and increased total color difference after 6 weeks of storage. The odor and flavor of both mashed potatoes and ground carrots were affected by light exposure. The mashed potato showed a slight reduction in freshness-odor for all materials with storage time. For flavor, mashed potato and ground carrot showed similar trends; flavor was scored unacceptable when packaged in PE films after 6 weeks, but when packaged in PA/PE and PE/EVOH films, the flavor was still acceptable after 10 weeks of storage.
Related Concept Videos
Sample Handling
Samples should be transported carefully from collection points to the laboratory. They should be properly sealed and clearly labeled to prevent cross-contamination. To preserve the sample integrity, optimal temperature conditions during transport are essential. This could involve using...
Factors Influencing Drug Absorption: Pharmaceutical Parameters
Mortar Properties
Formulation and Manufacturing Process: Physical Attributes of Generic Tablets and Capsules
Pasteurization and Food Preservation
Methods of Controlling Food Spoilage

