FPGA Implementation for 24.576-Gbit/s Optical PAM4 Signal Transmission with MLP-Based Digital Pre-Distortion

In this work, we implemented a short-reach real-time optical communication system using MLP for pre-distortion. Lookup table (LUT) algorithms are commonly employed for pre-distortion in intensity modulation and direct detection (IM/DD) systems. However, storage limitations typically restrict the LUT pattern length to 9, limiting its effectiveness in compensating for nonlinear effects. A multilayer perceptron (MLP) can overcome this limitation by predicting errors and generating pre-distorted signals, thus replacing the extensive storage requirements of LUTs with minimal computational resources. The MLP-based digital pre-distortion (MLP-DPD) technique enables the creation of long-pattern LUTs for improved nonlinear compensation. In this work, an MLP-DPD scheme was implemented on a field-programmable gate array (FPGA). The FPGA was used to generate a 14.7456 GBaud pre-distorted pulse amplitude modulation 4-level (PAM4) signal. This signal was then transmitted over 20 km of standard single-mode fiber (SSMF). At the receiver, the parallel constant modulus algorithm (PCMA) was applied for signal processing. The bit error rate (BER) achieved met the 2.4 × 10^-2 threshold for soft-decision forward error correction (SD-FEC), enabling a net transmission bit rate of 24.576 Gbit/s. This approach demonstrates the feasibility of using MLP-DPD for effective nonlinear compensation in high-speed optical communication systems with limited resources.