Non-uniform failure mechanism and stability control of mining roadway under deviatoric stress field
Tianhong Huo1,2, Hongtao Liu3,4, Shigen Fu5
1Institute of Mine Safety Technology, China Academy of Safety Science and Technology, Beijing, 100012, China. cumtbhth@126.com.
Abstract:
Based on the elastic-plastic theory, the analytical formula of the second invariant J2 of deviatoric stress at any point around the circular roadway under the non-uniform stress field is derived. The distribution law of J2 of surrounding rock under the three-dimensional non-isobaric stress field is studied by theoretical analysis and numerical simulation. Combined with the butterfly failure theory of surrounding rock of roadway, the close relationship between the distribution pattern of J2 and the distribution pattern of plastic zone is found, and the failure mechanism of surrounding rock is revealed. The results show that the distribution form of the second invariant J2 of deviatoric stress is closely related to the distribution form of plastic zone. When the distribution of J2 of surrounding rock shows 'round', 'oval' and 'butterfly', the plastic zone shows the corresponding consistent form. When the second invariant J2 of deviatoric stress produces stress concentration, the surrounding rock of roadway will produce large-scale damage. When the stress concentration is high, it may lead to malignant expansion of surrounding rock of roadway. The distribution of the second invariant J2 of deviatoric stress is directional. When the principal stress rotates over a certain angle, the second invariant J2 of deviatoric stress rotates over the same angle as the plastic zone. Under the influence of superimposed mining, the second invariant deviatoric stress J2 of the wind tunnel of Yangchangwan 160,206 working face presents butterfly distribution, and the stress butterfly leaves present a certain degree of rotation. Based on the failure mode of plastic zone, the corresponding optimization support scheme is proposed, and the engineering effect is good.
More Related Videos
07:37Full-field Strain Measurements for Microstructurally Small Fatigue Crack Propagation Using Digital Image Correlation Method
Published on: January 16, 2019
10:36Stress Distribution During Cold Compression of Rocks and Mineral Aggregates Using Synchrotron-based X-Ray Diffraction
Published on: May 20, 2018
Related Concept Videos
Yield Criteria for Ductile Materials under Plane Stress
The Maximum Shearing Stress Criterion, also known as...
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Stress-Strain Diagram - Ductile Materials
Design of Transmission Shafts - Stress Analysis
Stress Concentrations in Circular Shafts
Behavior of Concrete Under Compressive Load
As the concrete specimen fractures under...
