A high capacity data recording device based on a digital audio processor and a video cassette recorder

Related Experiment Video

Updated: Nov 6, 2026

Micro-drive Array for Chronic in vivo Recording: Drive Fabrication
14:03

Micro-drive Array for Chronic in vivo Recording: Drive Fabrication

Published on: April 19, 2009

F Bezanilla

    Biophysical Journal
    |March 1, 1985
    PubMed

    More Related Videos

    Examining Recall Memory in Infancy and Early Childhood Using the Elicited Imitation Paradigm06:35

    Examining Recall Memory in Infancy and Early Childhood Using the Elicited Imitation Paradigm

    Published on: April 28, 2016

    Hybrid Microdrive System with Recoverable Opto-Silicon Probe and Tetrode for Dual-Site High Density Recording in Freely Moving Mice08:57

    Hybrid Microdrive System with Recoverable Opto-Silicon Probe and Tetrode for Dual-Site High Density Recording in Freely Moving Mice

    Published on: August 10, 2019

    Related Concept Videos

    Data Reporting and Recording01:24

    Data Reporting and Recording

    Reporting and recording are crucial in data documentation. The timely, thorough, and accurate documentation of facts is essential when recording patient data. Failure to record findings during an assessment or interpretation of a problem will result in loss of information and make the patient document unreliable. The reader is left with general impressions if the information is not specific. A recording is documenting data of the individual's health information in a traceable, secure, and...
    Capacitors01:15

    Capacitors

    Capacitors play a crucial role in car radios, where they filter and store frequencies to ensure clear signal reception. Essentially serving as energy storage devices, capacitors store energy within their electric field and are composed of two parallel conducting plates separated by a dielectric.
    When a voltage source is connected to a capacitor, positive and negative charges accumulate on the opposite plates. This accumulation generates a potential difference that equals the product of the...
    Design Example: Vintage Mixing Console01:17

    Design Example: Vintage Mixing Console

    A sound engineer at a music company recently encountered a problem. The output from their newly acquired studio's vintage mixing console was too low for the requirements of modern recording equipment. To rectify this situation, the engineer decided to design an audio pre-amplifier using an operational amplifier (op-amp) to boost the signal level.
    The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...
    Clipper Circuit01:18

    Clipper Circuit

    A clipper circuit is a fundamental wave-shaping device that harnesses the unique properties of diodes to alter and control waveform characteristics. This technology is widely used in electronic devices, especially in television and radar communication systems, where it enhances waveform modulation in both transmitters and receivers.
    The operation of a clipper circuit can be exemplified by analyzing a dual-clipper configuration setup that integrates two ideal diodes, each paired with a biasing...
    Clamper Circuit01:14

    Clamper Circuit

    A clamper circuit, also known as a DC restorer, represents a specialized variant of the rectifier circuit, notable for its method of taking the output across the diode rather than the capacitor. This configuration lends to several distinctive applications, particularly in handling square wave inputs.
    Within this circuit, the diode's orientation prompts the capacitor to charge up to the level of the most negative peak of the input signal. Upon reaching this state, the diode ceases to conduct,...
    Voltage Doubler Circuit01:23

    Voltage Doubler Circuit

    A voltage doubler circuit integrates two main components: a clamping section and a rectifier section. The clamping section consists of a capacitor (C1) and a diode (D1), whereas the rectifier section is equipped with another diode (D2) and capacitor (C2). This circuit produces an output voltage with twice the amplitude of the sinusoidal input voltage.