Related Experiment Video
Updated: Jun 3, 2025

Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing
Published on: December 3, 2013
Phase transitions, Dirac and Weyl semimetal states in Mn1-xGexBi2Te4
A M Shikin1, N L Zaitsev2,3, T P Estyunina2
1Saint Petersburg State University, St. Petersburg, 198504, Russia. ashikin@inbox.ru.
Abstract:
Using angle-resolved photoemission spectroscopy (ARPES) and density functional theory (DFT), an experimental and theoretical study of changes in the electronic structure (dispersion dependencies) and corresponding modification of the energy band gap at the Dirac point (DP) for topological insulator (TI) [Formula: see text] have been carried out with gradual replacement of magnetic Mn atoms by non-magnetic Ge atoms when concentration of the latter was varied from 10% to 75%. It was shown that when Ge concentration increases, the bulk band gap decreases and reaches zero plateau in the concentration range of 45-60% while trivial surface states (TrSS) are present and exhibit an energy splitting of 100 and 70 meV in different types of measurements. It was also shown that TSS disappear from the measured band dispersions at a Ge concentration of about 40%. DFT calculations of [Formula: see text] band structure were carried out to identify the nature of observed band dispersion features and to analyze the possibility of magnetic Weyl semimetal state formation in this system. These calculations were performed for both antiferromagnetic (AFM) and ferromagnetic (FM) ordering types while the spin-orbit coupling (SOC) strength was varied or a strain (compression or tension) along the c-axis was applied. Calculations show that two different series of topological phase transitions (TPTs) may be implemented in this system, depending on the magnetic ordering. In the case of AFM ordering, the transition between TI and the trivial insulator phase passes through the Dirac semimetal state, whereas for FM phase such route admits three intermediate states instead of one (TI-Dirac semimetal-Weyl semimetal-Dirac semimetal-trivial insulator). Weyl points that form in the FM system along the [Formula: see text] direction annihilate when either the SOC strength decreases or a sufficient tensile strain is applied, which is accompanied by the corresponding TPTs. Model calculations of the influence of local magnetic ordering in AFM [Formula: see text] were carried out by alternating Mn layers with Ge-doped layers and showed that the magnetic Weyl semimetal state in this system is reachable at a Ge concentration of approximately 40% without application of any external magnetic fields.
More Related Videos
10:42Combining Solid-state and Solution-based Techniques: Synthesis and Reactivity of ChalcogenidoplumbatesII or IV
Published on: December 29, 2016
09:06Visualizing Uniaxial-strain Manipulation of Antiferromagnetic Domains in Fe1+YTe Using a Spin-polarized Scanning Tunneling Microscope
Published on: March 24, 2019
Related Concept Videos
Colors and Magnetism
When atoms or molecules absorb light at the proper frequency, their electrons are excited to higher-energy orbitals. For many main group atoms and molecules, the absorbed photons are in the ultraviolet range of the electromagnetic spectrum, which cannot be detected by the human eye. For coordination compounds, the energy difference between the d orbitals often allows photons in the visible range to be absorbed and emitted, which is seen as colors by the human...
Properties of Transition Metals
Bonding in Metals
Fermi Level
At absolute zero temperature, electrons fill all energy states up to the Fermi level, leaving upper states empty. As the temperature rises,...
Valence Bond Theory
Theory of Metallic Conduction
In this theory, Newton's second law of motion is used to determine the acceleration of an electron in the presence of an applied electric field. Then, its velocity is expressed via this acceleration.
An electron moves through the crystal, containing positive ions,...