Related Experiment Video
Updated: Jul 26, 2026

Development of a 3D Graphene Electrode Dielectrophoretic Device
Published on: June 22, 2014
Rheological, electrochemical, and microstructural properties of graphene oxides as flowable electrodes for energy
André Pincot1,2, Jeffrey Chin1,3, Ryan Murphy4
1Department of Chemistry and Life Science, United States Military Academy West Point NY 10996 USA enoch.nagelli@westpoint.edu.
Abstract:
Interest in novel energy storage and conversion methods has prompted a broad interest in potential applications of conductive, complex materials such as graphene oxide slurries. Investigating the complex rheological, material, and chemical properties of chemically exfoliated graphene oxide suspensions is a potential means to address that interest. The morphological size and clustering, rheology, and electronic conductivity are determined to characterize the properties of graphene oxide (GO) suspensions from variable centrifugation speeds. The evolution of viscosity is then analyzed under oscillatory shear, steady shear, and transient shear characteristics. The resulting microstructure is then analyzed via neutron scattering analysis and imaged with scanning electron microscopy. Small-Angle Neutron Scattering (SANS) of a 500g centrifuged GO suspension determined that particle structure is locally flat sheet-like at lengths below 100 nm, crumpled aggregates of GO sheets with surface roughness at length scales from 200 nm to 2 μm, and a dense mass fractal of overlapping GO sheets extending up to length scales of 20 μm. Increased centrifugation force of the 1000g GO suspension corresponded with lower zero-shear viscosity, yield stress, and less pronounced thixotropic behavior. Rheo-dielectric measurements were conducted on 1000g and 500g GO suspensions to determine the ohmic resistance, electronic conductivity, and specific capacitance. The more fluid-like microstructure of 1000g with smaller monodispered thinning GO sheets in suspension had lower ohmic resistance and higher electronic conductivity compared to the 500g GO suspension with more polydispersed larger aggregates. The 1000g GO suspension had the highest specific capacitance of 4.63 mF cm-2 at the highest shear rate of 700 s-1 due to the higher frequency of particle-particle collisions during shear within the network of smaller and more intrinsically conductive GO sheets to store charge. Therefore, the results of this study have implications for future studies in flowable carbon nanomaterials in flow battery and flow capacitor technologies.
More Related Videos
09:49A Protocol for Electrochemical Evaluations and State of Charge Diagnostics of a Symmetric Organic Redox Flow Battery
Published on: February 13, 2017
07:51Development and Functionalization of Electrolyte-Gated Graphene Field-Effect Transistor for Biomarker Detection
Published on: February 1, 2022
Related Concept Videos
Batteries and Fuel Cells
Energy Stored in a Capacitor
Electrochemical Cells
The Electrical Double Layer
Processes at Electrodes
Microbial Fuel Cells