Related Experiment Video
Updated: May 5, 2026

Measuring Sub-23 Nanometer Real Driving Particle Number Emissions Using the Portable DownToTen Sampling System
Published on: May 22, 2020
Does distance from the vehicle headlight change the properties of particulate matter?
Pak Kin Wong1, Meisam Ahmadi Ghadikolaei2, Adebayo Afolabi Fadairo3
1Department of Electromechanical Engineering, University of Macau, Taipa, Macau.
Abstract:
Understanding factors affecting particulate matter (PM), particularly light exposure from vehicle headlights, is essential for addressing air quality challenges. However, no comprehensive studies are available. This research, therefore, aims to investigate whether light produced by the vehicle headlight (Halogen type; 12V-55w) at various distances (120 cm, 70 cm, and 20 cm) for 1 hr affects the physical and thermal features of PM obtained from a gasoline vehicle at idle speed. The findings indicate that light can significantly change the properties of PM, especially at a close distance of 20 cm. However, as the distance increases, the effectiveness of light decreases, showing almost no impact at 120 cm. At 20 cm, PM shows higher primary particle diameters (42.1 %), core size/particle size ratio (15.2 %), fringe separation distance (12.4 %), low-volatile substances (9.4 %), non-volatile substances (21.4 %), heat required for 5 %, 50 %, and 95 % reductions in PM mass (14.4 %, 41.7 %, and 13.7 %, respectively), and frequency factor (80.3 %), as well as lower shell size/core size ratio (17.4 %), fringe length (9.9 %), PM mass (21.4 %) and high-volatile substances (8.1 %) compared to no light condition. While, fractal dimension, mean radius of gyration, length/width ratio, roundness, fringe tortuosity, soot ignition temperature, and activation energy are almost identical.
Related Concept Videos
Physical and Chemical Properties of Matter
Photoelectric Effect
Doppler Effect - I
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Variables Affecting Phosphorescence and Fluorescence
Introduction to Limits

