Related Experiment Video

Updated: May 23, 2025

Ammonia Synthesis at Low Pressure
08:14

Ammonia Synthesis at Low Pressure

Published on: August 23, 2017

26.4K

Effect of Amines on MIL-101(Cr) for Simultaneous H2S/CO2 Removal from Biogas

Chunyi Li1, MinGyu Song1, Ryan P Lively1

  • 1School of Chemical & Biomolecular Engineering, Georgia Institute of Technology, Atlanta, Georgia 30332, United States.

Energy & Fuels : an American Chemical Society Journal
|May 21, 2025
PubMed

More Related Videos

Hydrogen Production and Utilization in a Membrane Reactor10:00

Hydrogen Production and Utilization in a Membrane Reactor

Published on: March 10, 2023

2.2K
Synthesis of Metal Nanoparticles Supported on Carbon Nanotube with Doped Co and N Atoms and its Catalytic Applications in Hydrogen Production08:40

Synthesis of Metal Nanoparticles Supported on Carbon Nanotube with Doped Co and N Atoms and its Catalytic Applications in Hydrogen Production

Published on: December 6, 2021

3.5K

Related Concept Videos

Acid Halides to Amides: Aminolysis01:07

Acid Halides to Amides: Aminolysis

Aminolysis is a nucleophilic acyl substitution reaction, where ammonia or amines act as nucleophiles to give the substitution product. Acid halides react with ammonia, primary amines, and secondary amines to yield primary, secondary, and tertiary amides, respectively.
In the first step of the aminolysis mechanism, the amine attacks the carbonyl carbon of the acyl chloride to form a tetrahedral intermediate. In the second step, the carbonyl group is re-formed with the elimination of a chloride...
2.6K
Basicity of Heterocyclic Aromatic Amines01:25

Basicity of Heterocyclic Aromatic Amines

Heterocyclic amines, where the N atom is a part of an alicyclic system, are similar in basicity to alkylamines. Interestingly, the heterocyclic amine having a nitrogen atom as part of an aromatic ring has much less basicity than its corresponding alicyclic counterpart. For this reason, as presented in Figure 1, piperidine (pKb = 2.8) is significantly more basic than pyridine (pKb = 8.8).
5.5K
Nitriles to Amines: LiAlH4 Reduction00:55

Nitriles to Amines: LiAlH4 Reduction

Nitriles are reduced to amines in the presence of strong reducing agents like lithium aluminum hydride through a typical nucleophilic acyl substitution. The reaction requires two equivalents of the reducing agent. The reducing agent acts as a source of hydride ions.
As shown below, the mechanism involves three steps. Firstly, the hydride ion acting as a nucleophile attacks the nitrile carbon to form an anion. In the second step, a second equivalent of the hydride ion attacks the anion to...
3.2K
NMR Spectroscopy Of Amines01:19

NMR Spectroscopy Of Amines

In proton NMR spectroscopy, primary amines and secondary amines showcase their N–H protons as a broad signal in the chemical shift range between δ 0.5 and 5 ppm. The exact position in this range depends on several factors, including sample concentration, hydrogen bonding, and the type of solvent used. Since amine protons undergo fast proton exchange in solution, the protons are labile and therefore do not participate in any splitting with adjacent protons. Thus, the observed peak is...
8.4K
Amides to Amines: LiAlH4 Reduction01:20

Amides to Amines: LiAlH4 Reduction

Amide reduction with strong reducing agents like lithium aluminum hydride proceeds through a nucleophilic acyl substitution to form amines. Primary, secondary, and tertiary amides yield primary, secondary, and tertiary amines, respectively.
Amide reduction requires two equivalents of the reducing agent, acting as a source of hydride ions. As shown in the figure, the reaction is initiated with a nucleophilic attack by the hydride ion at the carbonyl carbon to form a tetrahedral intermediate.
4.5K
Preparation of Amines: Alkylation of Ammonia and Amines01:30

Preparation of Amines: Alkylation of Ammonia and Amines

Alkylation is one of the methods used to prepare amines. Direct alkylation of ammonia or a primary amine with an alkyl halide gives polyalkylated amines along with a quaternary ammonium salt through successive SN2 reactions. This process of making the quaternary salt through the direct alkylation method is called exhaustive alkylation.
Each alkylation step makes the nitrogen center more nucleophilic, which triggers successive alkylations until a quaternary ammonium salt is formed. Considering...
3.2K