Related Experiment Video
Updated: Sep 15, 2025

Probing the Structure and Dynamics of Interfacial Water with Scanning Tunneling Microscopy and Spectroscopy
Published on: May 27, 2018
A study of the atmospherically relevant reaction between dimethyl sulphide (DMS) and Cl2 in the absence and presence
Lydia Rhyman1,2, Edmond P F Lee3, Ponnadurai Ramasami1,2
1Computational Chemistry Group, Department of Chemistry, Faculty of Science, University of Mauritius, Réduit 80837, Mauritius. lyd.rhyman@gmail.com.
Abstract:
The thermodynamics and mechanisms of the atmospherically relevant reaction between dimethyl sulphide (DMS) and molecular chlorine (Cl2) were investigated in the absence and presence of a single water molecule, using electronic structure methods. Stationary points on the reaction surfaces were located using density functional theory (DFT) with the M06-2X functional and aug-cc-pVTZ (aVTZ) basis sets. Then single point energy calculations were carried out using the UM06-2X/aVTZ optimised stationary point geometries, with aug-cc-pVnZ basis sets (n = T and Q), using the domain-based local pair natural orbitals coupled cluster [DLPNO-UCCSD(T)] method, to give DLPNO-CCSD(T)/CBS//M06-2X/aVTZ relative energies. The reaction can proceed in three ways depending on the initial van der Waals complex formed i.e. via DMS + Cl2·H2O, DMS·H2O + Cl2, or DMS·Cl2 + H2O. It was found that based on computed equilibrium constants for complex formation and estimated initial concentrations of DMS, Cl2 and H2O in the atmosphere that [DMS·H2O] and [Cl2·H2O] are likely to be much greater than [DMS·Cl2] under atmospheric conditions. It was found that both with and without water the reaction can proceed by two pathways (i) formation of the products CH3SCH2Cl + HCl + (H2O) via a covalently bound intermediate (CH3)2SCl2(H2O) and (ii) formation of the products via a cis-CH3SClCH2:HCl (H2O) intermediate, where (H2O) applies to the with-water case. Although the pathways and mechanisms are similar in the without- and with-water cases, the relative energies of the transition states are significantly lower and the potential energy diagram is much more complex in the with-water case. However, under tropospheric conditions the overall DMS + Cl2 rate coefficient is unlikely to be affected by the presence of water as the concentrations of DMS·H2O and Cl2·H2O are estimated to be much lower than the concentrations of DMS, Cl2 and H2O. This work extends our earlier study of the reaction of DMS with atomic chlorine (Cl) with and without water (L. Rhyman et al., Phys. Chem. Chem. Phys. 2023, 25, 4780-4793).
Related Concept Videos
Preparation and Reactions of Sulfides
SN2 Reaction: Kinetics
In a chemical reaction, a relationship exists between the concentration of reactants and the rate at which the reaction proceeds. The study to measure this relationship is known as the kinetics of a chemical reaction. Kinetic studies are used to deduce the rate law of a chemical reaction, which provides information about the species involved during the transition state of the rate-determining step. Thus, kinetic studies help to derive the mechanism of a...
Preparation and Reactions of Thiols
Carboxylic Acids to Acid Chlorides
Molecular Shape and Polarity
Formation of Halohydrin from Alkenes
![The Synthesis of [Sn10SiSiMe334]2- Using a Metastable SnI Halide Solution Synthesized via a Co-condensation Technique](/_next/image?url=https%3A%2F%2Fcloudfront.jove.com%2FCDNSource%2Fteasers%2F54498.jpg&w=3840&q=50)
