Access to "speech glimpses" in multitalker mixtures afforded by non-linear hearing-aid gain with fast-acting

Virginia Best1

  • 1Department of Speech, Language and Hearing Sciences, Boston University, Boston, Massachusetts 02215, USA.

Related Concept Videos

Hearing01:31

Hearing

When we hear a sound, our nervous system is detecting sound waves—pressure waves of mechanical energy traveling through a medium. The frequency of the wave is perceived as pitch, while the amplitude is perceived as loudness.
53.0K
Perceiving Loudness, Pitch, and Location01:21

Perceiving Loudness, Pitch, and Location

The human brain perceives pitch through two primary mechanisms reflected in place theory and frequency theory. Each mechanism describes how sound waves are interpreted as specific pitches by the brain, offering insights into the intricate processes of auditory perception.
Place theory, or place coding, suggests that different pitches are heard because various sound waves activate specific locations along the cochlea's basilar membrane. The brain determines the pitch of a sound by...
420
Auditory Perception01:17

Auditory Perception

The auditory system is essential for sound perception, utilizing various critical structures. When sound waves enter the outer ear, they travel through the ear canal and cause the eardrum to vibrate. These vibrations are then transmitted to the middle ear, where three tiny bones – the malleus, incus, and stapes – amplify the sound. This amplification is crucial, as it ensures that the sound vibrations are strong enough to be conveyed to the inner ear. These vibrations then reach the...
580
Interference: Path Lengths01:10

Interference: Path Lengths

Consider two sources of sound, that may or may not be in phase, emitting waves at a single frequency, and consider the frequencies to be the same.
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
1.4K
Design Example: Vintage Mixing Console01:17

Design Example: Vintage Mixing Console

A sound engineer at a music company recently encountered a problem. The output from their newly acquired studio's vintage mixing console was too low for the requirements of modern recording equipment. To rectify this situation, the engineer decided to design an audio pre-amplifier using an operational amplifier (op-amp) to boost the signal level.
The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...
295