Related Experiment Video
Updated: Jan 18, 2026

Composition and Distribution Analysis of Bioaerosols Under Different Environmental Conditions
Published on: January 7, 2019
Impact of Chemical Composition on Aerosol Scattering: Insights from the Surface Particulate Matter Network and
Sujin Eom1, Sang Seo Park1,2, Xuan Liu3
1Department of Civil, Urban, Earth and Environmental Engineering, Ulsan National Institute of Science and Technology (UNIST), Ulsan 44919, Republic of Korea.
Abstract:
Using the Surface Particulate Matter Network (SPARTAN) and Aerosol Robotic Network (AERONET), we investigated the relationship between aerosol chemical composition and optical properties across 14 global sites. The mass concentrations of ammonium sulfate (AS), ammonium nitrate (AN), fine soil (FS), and black carbon (BC) from SPARTAN were collocated with aerosol optical properties (aerosol optical depth (AOD), fine mode fraction (FMF), and single scattering albedo (SSA)) from AERONET. Significant differences in the optical properties of samples from 2016 to 2023 were identified based on the mass and mass ratios of the chemical components. For the BC-FS relationship in the data set used in this study, increased FS mass lowered FMF and dSSABC-FS (SSA440-SSA870) by approximately 0.033 and 0.005 per 1 μg/m3, respectively. Higher ratios of nonabsorbing components (AS and AN) to BC (w = (AS + AN)/(AS + AN + BC)) increased SSA at all wavelengths. The correlation between w and SSA was stronger at longer wavelengths, with SSA440 and SSA1020 increasing by approximately 0.026 and 0.046 per 10% increase in w from the data set, respectivley. Site-specific results showed that dSSAw and rSSA (SSA440/SSA1020) increased as the BC proportion rose (w decreased). This study emphasizes the utility of both dSSA and rSSA, alongside single-wavelength SSA, in understanding aerosol behavior. Integrating columnar optical data with surface-level chemical measurements, the combined SPARTAN and AERONET approach offers valuable insight into aerosol classification, behavior, and atmospheric impacts.
Related Concept Videos
Atomic Emission Spectroscopy: Interference
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...

