Related Experiment Video
Updated: Jan 18, 2026

Anionic Polymerization of an Amphiphilic Copolymer for Preparation of Block Copolymer Micelles Stabilized by π-π Stacking Interactions
Published on: October 10, 2016
Effects of Poly(ethylene oxide) on the Foam Properties of Anionic Surfactants: Experiment and Molecular Dynamics
Chaohang Xu1, Ran Bi1, Sijing Wang1
1School of Safety Science and Emergency Management, Wuhan University of Technology, Wuhan 430070, China.
Abstract:
Water-soluble polymers are often used as additives to adjust the foam properties of surfactant. In this study, the effects of water-soluble polymer poly(ethylene oxide) (PEO) on foam properties of two anionic surfactants, i.e., ammonium lauryl ether sulfate (ALES) and sodium dodecyl sulfate (SDS), were investigated by experimental and molecular dynamics simulation methods. Experimental results show that the addition of PEO can reduce the foaming ability of the two surfactants, but the inhibitory effect of PEO on the foaming ability is weakened at high surfactant concentration. Compared with ALES, PEO has a more significant inhibitory effect on the foaming ability of SDS. With the increase in PEO concentration, the half-life time of foam drainage in surfactant/water-soluble polymer composite systems gradually increases. The synergistic effect between PEO and ALES is stronger than that between PEO and SDS, resulting in a longer half-life time of foam drainage in ALES/PEO composite system. Molecular dynamics simulation results indicate that the addition of PEO can decline the air-water interface thickness of bubble films and the tail tilt angle of surfactant molecules at the air-water interface. The reduction in tail tilt angle means that the surfactant molecules are more vertical to the air-water interface and the hydrophobic interaction between adjacent tail chains of surfactants is weakened, which is unfavorable to the formation of bubble films, thus decreasing the foaming ability of surfactants. Because the ALES/PEO system has larger air-water interface thickness and surfactant tail tilt angle than the SDS/PEO system, the inhibitory effect of PEO on the foaming ability of ALES is weaker than that of SDS. Adding PEO can lower the peak position of the first hydration layer of surfactant head groups, increase the number of hydrogen bonds, and reduce the diffusion coefficient of water molecules, so that the surfactant/water-soluble polymer system has longer half-life time of foam drainage than the pure surfactant system. Due to the synergistic effect between ALES and PEO, the ALES/PEO system has a higher peak value of the first hydration layer of surfactant head groups, more hydrogen bonds, and lower diffusion coefficient of water molecules than the SDS/PEO system. Therefore, the half-life time of foam drainage in the ALES/PEO system is longer than that in the SDS/PEO system.
More Related Videos
06:31Studying Surfactant Effects on Hydrate Crystallization at Oil-Water Interfaces Using a Low-Cost Integrated Modular Peltier Device
Published on: March 18, 2020
07:01Preparation of Hollow Polystyrene Particles and Microcapsules by Radical Polymerization of Janus Droplets Consisting of Hydrocarbon and Fluorocarbon Oils
Published on: January 25, 2018
Related Concept Videos
Molecular Weight of Step-Growth Polymers
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
Anionic Chain-Growth Polymerization: Overview
Colloids
Anionic Chain-Growth Polymerization: Mechanism