Related Experiment Video
Updated: Jan 17, 2026

Design and Use of a Full Flow Sampling System FFS for the Quantification of Methane Emissions
Published on: June 12, 2016
The horizontal plane method of fugitive emission rate measurement
1Horizontal Plane Corporation, Burnaby, British Columbia, Canada.
Abstract:
The horizontal plane method is a novel method of measuring fugitive emission rates that is based on the mass balance approach. Conventional mass balance approach methods measure concentrations or integrated concentrations of airborne matter across a substantially vertical measurement surface that is substantially perpendicular to the wind flow direction. In contrast, for the horizontal plane method, concentrations or integrated concentrations of airborne matter are measured across a substantially horizontal sampling surface that is substantially parallel to the wind flow direction. This characteristic allows users of the horizontal plane method to sample an entire cross-section of a plume that exceeds the operating ceiling of drones or if there is an operating floor for aircraft. A horizontal plane map may be used to estimate the plan location of individual emission sources. Since sampling is horizontal, there is also the potential to efficiently measure the fugitive emission rate of large areas or the fugitive emission rates of multiple sources over large areas. Optimal conditions to carry out the method include conducting the field work during daytime sunny weather and obtaining the concentration or integrated concentration measurements between an altitude of approximately 110 m and 120 m.A horizontal plane system, which incorporated the horizontal plane method to measure the upper portion of the plume and a conventional mass balance method to measure the lower portion of the plume, was applied at the Vancouver Landfill and a methane emission rate of the landfill of 181 g/s was measured. By comparison, a methane emission rate of 177 g/s was measured using the airborne matter mapping method that had been applied earlier the same afternoon, for a difference of approximately +2.5%. The horizontal plane map that was generated enabled the identification of the estimated location of four areas of the landfill with relatively high emission rates.Implications: Small drones are a low-cost and effective platform for measurement of fugitive emission rates. However, drones are subject to safety regulations that impose an operating ceiling, and this constrains their ability to measure emission rates, especially of large plumes, using available quantification methods. The novel horizontal plane method of fugitive emission rate measurement expands the capabilities of drones by allowing drones to operate within regulatory constraints even if the altitude of a plume exceeds the operating ceiling of drones. The method also provides a map that can be used to estimate the location of individual emission sources.
More Related Videos
10:29Calibrated Passive Sampling - Multi-plot Field Measurements of NH3 Emissions with a Combination of Dynamic Tube Method and Passive Samplers
Published on: March 21, 2016
08:59Measuring Sub-23 Nanometer Real Driving Particle Number Emissions Using the Portable DownToTen Sampling System
Published on: May 22, 2020
Related Concept Videos
Gas Chromatography: Types of Detectors-II
Flame Photometry: Overview
Pipe Flowrate Measurement: Problem Solving
Flame Photometry: Lab
Pipe Flowrate Measurement
The orifice meter is a simple,...
Measurement of Air Content in Concrete
The pressure method,...