Harnessing resistance: the impact of a passive exosuit on golf swing biomechanics

Alireza Nasirzadeh1, Song Min Lee2, Jihye Jang3

  • 1Department of Mechanical Engineering, Chung-Ang University, Seoul, South Korea.

Journal of Biomechanics
|September 19, 2025
PubMed

Related Concept Videos

Static and Kinetic Frictional Force01:05

Static and Kinetic Frictional Force

One of the simpler characteristics of sliding friction is that it is parallel to the contact surfaces between systems, and is always in a direction that opposes the motion or attempted motion of the systems relative to each other. If two systems are in contact and moving relative to one another, then the friction between them is called kinetic friction. For example, kinetic friction slows a hockey puck sliding on ice.
However, if two systems are in contact and are stationary relative to one...
20.5K
Power Expended by a Constant Force00:57

Power Expended by a Constant Force

The relationship between work done and the time taken to do it can be explained using the concept of power. For example, several sprinters in a race may have the same velocity when they reach the finish line, therefore doing the same amount of work, but the winner does it in the least amount of time. Thus, power is defined as the rate of doing work. Since work can vary as a function of time, the average power is defined as the work done during a time interval, divided by the time interval.
7.8K
Non-conservative Forces01:17

Non-conservative Forces

Non-conservative forces are dissipative forces such as friction or air resistance. These forces take energy away from a system as it progresses. Unlike conservative forces, non-conservative forces do not have potential energy associated with them. This is because the energy is lost to the system and cannot be turned into useful work later.
Also unlike their conservative counterparts, they are path-dependent; where the object starts and stops does matter. For example, a grinding wheel applies a...
8.1K
Force and Momentum01:17

Force and Momentum

Force and momentum are intimately related. Force acting over time can change momentum, and Newton's second law of motion can be stated in its most broadly applicable form in terms of momentum. Momentum can be applied to systems where the mass is changing, such as rockets, as well as to systems of constant mass. Also, momentum continues to be a key concept in the study of atomic and subatomic particles in quantum mechanics. One can consider systems with varying mass in some detail; however, the...
19.5K
Frictional Forces on Flat Belts01:28

Frictional Forces on Flat Belts

Flat belts are commonly used in various industrial applications for transmitting power from one pulley to another. When a flat belt is wrapped around a set of pulleys, it experiences different tensions at the driving pulley ends due to the friction between the belt and pulley surface. When the pulley moves in a counterclockwise direction, the tension T2 on the opposite side of the pulley where the belt is moving away from is higher than the tension T1 on the side where the belt is moving...
1.8K
Impact Loading01:19

Impact Loading

Impact loading occurs when a moving object collides with a stationary structure, such as a rod with a uniform cross-sectional area fixed at one end. Under these conditions, the rod absorbs the kinetic energy from the striking object, leading to deformation and subsequent stress development. As the rod returns to its original position and reaches maximum stress, the absorbed energy, initially manifested as kinetic energy, transforms entirely into strain energy.
In cases of elastic deformation,...
963