Related Experiment Video
Updated: Jan 10, 2026
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
Effect of chemical post-processing on the compressive strength of MSLA 3D printed orthodontic models: an in vitro
Neha Choudhary1, Deepankar Bhatnagar1, Swapna Sreenivasagan2
1Department of Orthodontics Dentofacial Orthopaedics, MM College of Dental Sciences & Research, Maharshi Markandeshwar (Deemed to be University) Mullana, Ambala, Haryana, India.
Introduction:
Three-dimensional (3D) printing, particularly Masked Stereolithography (MSLA), has emerged as a transformative technology in orthodontics for the fabrication of precise dental models. However, the mechanical integrity of these models, especially compressive strength, is critical during procedures such as thermoforming of clear aligners. This study aimed to evaluate the effect of different chemical post-processing methods on the compressive strength of MSLA-printed dental models.
Materials And Method:
A total of 40 cylindrical resin samples (10 mm in height and 5 mm in diameter) were fabricated using an MSLA printer and divided into four groups (n = 10). Group 1: untreated group (acted as the control group), while Groups 2, 3, and 4 were treated with acetone, propylene glycol, and isopropyl alcohol, respectively. All treated samples were immersed in their respective chemicals for 5 min at room temperature. The compressive strength of each sample was measured utilising a Universal Testing Machine (UTM), and results were statistically analysed using Analysis of Variance (ANOVA) followed by Tukey's post hoc test.
Results:
The compressive strength varied with statistical significance among the groups (p = 0.001). Compared to the untreated control group (107 ± 35 MPa), post-processing in propylene glycol (139 ± 48 MPa) or isopropyl alcohol (106 ± 10 MPa) resulted in statistically similar compressive strength, whereas post-processing in acetone (86 ± 19 MPa) led to significantly lower compressive strength. Furthermore, post-processing in propylene glycol resulted in significantly higher compressive strength than did post-processing in isopropyl alcohol or acetone. Propylene glycol showed greater variability, which makes its beneficial properties questionable.
Conclusion:
In conclusion, chemical post-processing significantly influences the compressive strength of MSLA-printed models. Acetone had a deleterious impact on compressive strength. Isopropyl alcohol proved to be an acceptable solvent. Propylene glycol showed large variability in results, warranting further investigation.
