Spatial variation of litter density and associated PAHs leakage on Aras River bank

Mahmood Yousefi1,2, Javad Torkashvand3, Masoud Yousefi4

  • 1Student Research Committee, Khoy University of Medical Sciences, Khoy, Iran.

Scientific Reports
|December 7, 2025
PubMed

Related Concept Videos

Atomic Absorption Spectroscopy: Interference01:25

Atomic Absorption Spectroscopy: Interference

Interference leads to systematic error in atomic absorption (AA) measurements by enhancing or diminishing the analytical signal or the background. These interferences can be grouped into three main categories: spectral interference, chemical interference, and physical interference.
Spectral interference occurs when signals from other elements or molecules overlap with the analyte signal, falsely elevating or masking the analyte's absorbance. This interference can be corrected using Zeeman,...
Gas Solubility01:31

Gas Solubility

Gas solubility in liquids forms liquid-gas solutions, such as soft drinks, where carbon dioxide is dissolved in water, and the ocean, where the solubility of oxygen and carbon dioxide supports marine life. The ability of oceans to dissolve gases impacts weather conditions in the troposphere.However, gas-liquid interactions vary. For instance, hydrogen chloride gas is highly soluble in water, while oxygen's solubility is much lower. Because these solutions are non-ideal, Raoult’s law, which...
Porosity and Absorption of Aggregate01:20

Porosity and Absorption of Aggregate

Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the aggregate...
Deleterious Substances in Aggregate01:25

Deleterious Substances in Aggregate

Deleterious substances in aggregates can be detrimental to the quality and durability of concrete. These substances include organic impurities like loam, which interfere with cement hydration and are usually present in the sand. These prevent a good bond between aggregate and cement paste. Organic impurities can be detected using the colorimetric test, where the darkness of a solution after agitation indicates the level of organic content.
Another type of impurity is clay and fine material that...