Fault Diagnosis of Static Eccentricity in Marine Diesel Generators Using 2D Short-Time Fourier Transform of...

Static eccentricity is an important early-stage fault in marine diesel generators, as small air-gap deviations caused by misalignment or mechanical wear can escalate into bearing damage and rotor-stator contact. To address the challenge of detecting such subtle faults, this study proposes a current signal analysis method based on the two-dimensional short-time Fourier transform (2D STFT) for early detection of static eccentricity faults in marine diesel generators. Using three-phase currents measured during normal operation and fault data synthesized with a physics-based electromechanical coupling model (1-5% eccentricity), we construct a two-dimensional phase-time representation rather than treating each phase as an independent one-dimensional time series and then apply 2D STFT. This formulation enables the simultaneous capture of inter-phase relationships and spatial patterns in the time-frequency-phase domain. Experiments indicate a distinct energy rise near 1020 Hz as static eccentricity increases. This trend enables the proposed method to distinguish small faults of approximately 5% eccentricity, which remain difficult to detect using conventional 1D STFT. As a result, the approach improves the diagnostic accuracy of non-contact, current-based monitoring for static eccentricity faults. Future work will include validation using real in-service fault data and extensions to other fault modes such as dynamic eccentricity and bearing defects.