Meta-analysis of handgrip strength in subjects with high-normal or mildly increased uric acid compared to low-normal

Faustino R Pérez-López1, Ana M Fernández-Alonso2, Susana Aidé3

  • 1Department of Obstetrics and Gynaecology, Faculty of Medicine, University of Zaragoza, Zaragoza, Spain.

Abstract

Related Concept Videos

Titration of a Weak Base with a Strong Acid01:20

Titration of a Weak Base with a Strong Acid

The titration curve of a weak base like ammonia with a strong acid like hydrochloric acid is the mirror image of the titration curve of a weak acid with a strong base.
Using the ICE table and substituting the Kb value, we calculate the initial pH of 50 mL of 0.1 M ammonia to be 11.11. Addition of 25 mL of 0.1 M hydrochloric acid to this solution of ammonia results in a buffer with an equal concentration of ammonia and ammonium ions. The pH of this buffer can be calculated by substituting these...
9.1K
Solution Composition During Acid/Base Titrations01:17

Solution Composition During Acid/Base Titrations

The titration of a weak acid with a strong base results in the formation of water and the conjugate base of the acid. For instance, titrating acetic acid with sodium hydroxide leads to the formation of water and sodium acetate. A solution of acetic acid and sodium acetate constitutes a buffer whose relative concentration at different stages of the titration is indicated by the α values, which represent percentages of the weak acid and its conjugate base.
The α0 and α1 values...
2.0K
Composition of Polyprotic Acid Solutions as a Function of pH01:19

Composition of Polyprotic Acid Solutions as a Function of pH

Polyprotic acids of the type H2M constitute two ionizable protons. As a result, on titration with a base, they exhibit two equivalence points in the titration curve. During titration, the species H2M, HM−, and M2− will be present in the solution at different points. The fractions of H2M, HM−, and M2− present at the various instances of the titration are denoted by α0, α1, and α2, respectively.
A graph with the alpha values is plotted against the volume of...
1.2K
Conductometric Titrations: Strong Acid-Base and Weak Acid-Base Titrations01:29

Conductometric Titrations: Strong Acid-Base and Weak Acid-Base Titrations

In acid-base titrations, conductance measurements are utilized to detect the endpoint. This method is grounded on the fact that electrical conductance relies on the number and mobility of ions. For instance, consider titrating strong acid HCl with a strong NaOH base. Initially, the HCl in the conductivity vessel conducts electricity due to the presence of hydrogen ions and chloride ions. As NaOH is gradually added from the burette, the fast-moving hydrogen ions are replaced by slower-moving...
199
Conductometric Titrations: Strong Acid-Weak Base and Weak Acid-Strong Base Titrations01:22

Conductometric Titrations: Strong Acid-Weak Base and Weak Acid-Strong Base Titrations

When a weak acid such as acetic acid is titrated against a strong base like sodium hydroxide, the initial conductance is relatively low due to the weak dissociation of acetic acid. However, as sodium hydroxide is added to the solution, it reacts with the acetic acid to produce highly ionized sodium acetate, which causes an increase in conductance. Once all the acetic acid has been neutralized, any additional sodium hydroxide introduces fast-moving hydroxyl ions, leading to a sharper increase in...
195
Urine Studies I: Urinalysis01:29

Urine Studies I: Urinalysis

Urinalysis is a widely used diagnostic test that analyzes urine's physical, chemical, and microscopic characteristics. Healthcare providers use it to detect and monitor various health conditions, including renal disease, urinary tract infections (UTIs), diabetes, and metabolic or systemic disorders.Components of UrinalysisUrinalysis consists of three primary components: physical, chemical, and microscopic examination. Each provides unique insights into the urine sample and, by extension, the...
2.6K