Numerical Investigation of Material Flow and Defect Formation in FRAM-6061 Al Alloy Ring Component Using CEL...

In this study, a novel and efficient solid-state additive manufacturing technique, friction rolling additive manufacturing (FRAM), was employed to fabricate an aluminum alloy ring component, significantly reducing process complexity and mitigating solidification defects typical of melt-based techniques. However, previous studies on FRAM have primarily focused on the microstructural characteristics and mechanical properties of flat components, with limited attention paid to ring-shaped components. Owing to the unique geometric constraints imposed during the forming process, ring components exhibit markedly different microstructural evolution and defect formation mechanisms compared with flat counterparts, and these mechanisms remain insufficiently and systematically understood. To address this knowledge gap, the coupled Eulerian-Lagrangian (CEL) method was introduced for the first time to numerically simulate the temperature distribution and residual stress evolution during the FRAM process of ring-shaped components. In addition, tracer particles were incorporated into the simulations to analyze the material flow behavior, thereby systematically elucidating the forming behavior and microstructural evolution characteristics under geometric constraint conditions. Moreover, scanning electron microscopy (SEM) and electron backscatter diffraction (EBSD) were employed to systematically characterize the microstructural evolution and defect morphology. The CEL numerical simulations exhibited good consistency with the experimental observations, demonstrating the reliability and accuracy of the simulation method. The results showed that the peak temperatures were primarily concentrated at the advancing side of the rotation tool, and the temperature on the outer diameter side of the ring was consistently higher than that on the inner diameter side. The lack of shoulder friction on the inner side led to an increased heat dissipation rate, thereby resulting in higher residual stress compared to other regions. The particle analysis revealed that, due to ring geometry, material flow varied across radial regions, resulting in distinct microstructures. Further EBSD analysis revealed that, after the rotating tool passed, the material first developed a preferential orientation with {111} planes parallel to the shear direction, and with more layers, dynamic recrystallization produced an equiaxed grain structure. This study provides a theoretical basis and process reference for the application of the FRAM technique in the manufacturing of large ring components.